Advertisement
DC IN: 24V DC INPUT, 5.5x2.5mm Barrel DC jack, positive center. Note: Overvoltage above 24V might
permanently damage the amplifier.
POWER ON/OFF SWITCH: The switch turns on/off the amplifier.
FOOTSWITCH: S66 provide different footswitch jacks for controlling Tremolo on/off, Channel switching,
and FX loop engaging/bypassing.
-
TREMOLO Footswitch jack: 1/4" Mono latch type, tremolo turns on when tip and sleeve are shorted.
-
CHANNEL Footswitch jack: 1/4" Mono latch type, S66 switches to lead/rhythm channel when the tip and
sleeve are short/open.
-
FX LOOP Footswitch jack: 1/4" Mono latch type, S66 engages/bypasses effects loop when the tip and
sleeve are short/open.
-
FS-P3 jack: This jack connects to a specially designed 3-in-1 (tremolo, channel, and effects loop)
footswitch "FS-P3" with a standard RJ-11 6P cord. Note: FS-P3 is not included in the basic BJF-S66
product.
The control priority of 1/4" footswitch jack is higher than FS-P3, of which the priority is higher than
toggle switch on the front panel. For example, when FS-P3 is connected, the tremolo toggle switch and
channel switch on the front panel don't control, while if 1/4" tremolo jack is inserted with a cable, the
tremolo footswitch on FS-P3 doesn't control.
OUTPUT: S66 have two output jacks.
-
SPEAKER jack: Connects to cabinet, it outputs 30W/16Ω , or 66W/8Ω , or 100W/4Ω.
-
PREAMP jack: Outputs the preamp signal to a power amplifier or IR amp & cab.
EFFECTS LOOP: The effects loop is in front of internal reverb module.
-
SEND jack: Connects to input of guitar pedal or other instruments.
-
RETURN jack: Connects to output of guitar pedal or other instruments.
Rear Panel
Advertisement
