Control 4 Speaker Point Installation Manual

Speaker Point Installation Guide
Supported Models
This installation and user guide covers this Speaker Point model(s):
AVE-RAA1-B Ethernet Speaker Point
General Description
The Speaker Point is intended for Control4 system users who want to
add new audio zones to their home using an easy and cost effective
method. Users can locate the Speaker Point in remote locations to
enable audio zones beyond the area near the audio rack.
It is an end point of digital audio distribution and can be used to
amplify and distribute an audio source to bookshelf speakers in
remote locations throughout the home. It receives a digital audio
signal from a source via Ethernet, Wi-Fi or line in and distributes that
audio directly through a pair of connected speakers. The Speaker
Point transmits the source information and is controlled via an
Ethernet connection or its built-in Zigbee wireless connection.
The Speaker Point is designed with a compact profile and small
footprint so that it can be located discreetly throughout the home
(such as on a bookshelf, an overhead plant shelf, or even in attic
space). It is a small box (less than ½ rack size, approximate
dimensions are 1.5" Tall x 6.5" Wide x 6.5" deep). Its unique design
allows it to be stored horizontally or vertically (with the special bracket
included). If a user chooses to place a Speaker Point in his standard
EIA rack of components, then the rack shelf must be set at one rack
unit high to hold the unit.
The Speaker Point has one stereo speaker pair output and one
analog output for external power amps. The on-board digital 50 watt
per channel amplifier powers local bookshelf or in-wall speakers. The
user has the ability to adjust bass, treble, loudness, balance and mute
from local controls.
WARNING! To reduce the risk of serious injury or death, turn all power
OFF before installing this product.
WARNING! This product generates heat. The device must be
operated within specified operating temperature limits.
CAUTION! Using this product in a manner other than outlined in this
document voids your warranty. Further, Control4 is NOT liable for any
damage incurred with the misuse of this product. See "Limited 1 Year
Warranty."
About the Hardware
Front Panel
1.
2.
3.
4.
5.
Back Panel
Included Accessories
•
•
•
Control4 Speaker Point Installation Guide
1
2
IR reader (behind the window)
Data LED to indicate music is currently streaming in or out.
Link LED to indicate a network connection is present.
Power LED to indicate when power is present.
Identification and Reset button: To identify this device during
setup and will reset this device when pressed for longer than 10
seconds.
(Placeholder Graphic)
Label or Connector Type
Description
+36VDC@3.75A AC In power pLug Port
Right Speaker
Left Speaker
AudioOut RCA (Pre-Amp)
Audio In RCA
Ethernet RJ-45 port
USB USB Wi-Fi 802.11g port (Disabled in this model)
IR Out For 1 IR out emitter
Power cable and adapter with power plug
Vertical Mount Bracket
Speaker Point Installation Guide (this document)
3 4 5
Five Way Binding Post (+Red/-Black)
Five Way Binding Post (+Red/-Black)
1