NuAire UNI-X Series Installation Manual
NuAire UNI-X Series Installation Manual

NuAire UNI-X Series Installation Manual

Supply & extract with heat recovery

Advertisement

1.0 SAFETY INFORMATION
The provision of the electrical supply and the connection of the unit to the mains must be
carried out by a qualified electrician.
Isolate from power supply before removing any covers. During installation / maintenance ensure
all covers are fitted before switching on the mains supply.
All-pole disconnection from the mains as shown in the wiring diagram must be incorporated
within the fixed wiring and shall have a minimum contact separation of 3mm in accordance with
latest edition of the wiring regulations.
This unit must be earthed.
Ducting must be securely fixed with screws to the spigot to prevent access to live parts. Duct
runs terminating close to the fan must be adequately protected by suitable guards.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Precautions must be taken to avoid the back-flow of gases into the room from the open flue of
gas or other fuel-burning appliances.
This appliance should not be used by children or persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision
or instruction concerning the safe use of the appliance by a person responsible for their safety.
Children shall not play with the appliance. Cleaning and user maintenance shall not be carried
out by children.
1.1 Symbols
GENERAL WARNING
Signifies a general warning regarding hazard specified by supplementary information.
ELECTRIC SHOCK
This unit must be completely electrically isolated before any panels are removed. Check
mains supply and control connections.
ROTATING PARTS
This unit contains fast moving rotational parts which may start automatically. It is the
sole responsibility of the installer to adequately guard these components.
REFER TO INSTRUCTION MANUAL
Read and understand the installation and maintenance manual before installing,
operating or maintaining this product.
Nuaire |
Western Industrial Estate
UNI-X
Supply & Extract With Heat Recovery
Installation Manual
|
|
| nuaire.co.uk
Caerphilly
CF83 1NA
17. 06. 20. Document Number 671789
EMC Directive
2014/30/EU
LVD Directive
2014/35/EU
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UNI-X Series and is the answer not in the manual?

Questions and answers

Summary of Contents for NuAire UNI-X Series

  • Page 1 REFER TO INSTRUCTION MANUAL Read and understand the installation and maintenance manual before installing, operating or maintaining this product. Nuaire | | nuaire.co.uk 17. 06. 20. Document Number 671789 Western Industrial Estate...
  • Page 2: Personal Protective Equipment

    The weight of the unit modules and palletised items is displayed on the unit rating plate or on the packaging. Some of the modules have an Nuaire would always recommend a site specific risk assessment by a uneven weight distribution, and this will be indicated by labelling where competent person to determine if any additional PPE is required.
  • Page 3: Condensate Drain

    (this is essential to ensure that condensate drains correctly). ensure correct operation. Offset spigots have been included in the unit for greater flexibility in Nuaire recommend MVHR-DRAIN be used as the primary the layout of the ductwork. condensate take-off. The correct installation position for the units shall be decided with due 3.3.1 MVHR-DRAIN Installation...
  • Page 4 1136 1216 Rectangular Unit Mounting Hole Centres Dimensions Plan View Condensate Pipe Connection Hole Centre Dimensions (mm) Unit Code UNI-X220 UNI-X360 1031 UNI-X580 1091 Nuaire | | nuaire.co.uk 17. 06. 20. Document Number 671789 Western Industrial Estate Caerphilly CF83 1NA...
  • Page 5: Plan View

    Circular Spigot Unit Mounting Hole Centres Dimensions Plan View Condensate Pipe Connection Hole Centre Dimensions (mm) Unit Code UNI-X220-C UNI-X360-C 1031 UNI-X580-C 1091 935.6 467.8 Nuaire | | nuaire.co.uk 17. 06. 20. Document Number 671789 Western Industrial Estate Caerphilly CF83 1NA...
  • Page 6: Electrical Installation

    When wiring a unit that serves multiple bathrooms, the wiring shown as a dashed line can be repeated for the appropriate number of bathrooms. Nuaire | | nuaire.co.uk 17. 06. 20. Document Number 671789 Western Industrial Estate Caerphilly CF83 1NA...
  • Page 7: Maintenance

    Indoor temp > Outdoor temp as required. Inside temp > 25°C •Any drain trays should be cleaned and repaired if necessary. Nuaire | | nuaire.co.uk 17. 06. 20. Document Number 671789 Western Industrial Estate Caerphilly...
  • Page 8: Warranty

    Clause 14 of our Conditions of Sale. Customers purchasing from Filters can be accessed within the unit by removing the two filter covers outside of the UK should contact Nuaire International Sales office for on the bottom panel of the unit. Take hold of the two circular tabs further details.

This manual is also suitable for:

Uni-x360-cUni-x220-cUni-x580cUni-x580Uni-x220Uni-x360

Table of Contents