Advertisement
3.
Open arm, place shortest width of bag across
Teflon strip, and press arm down. Red indica-
tor light will illuminate.
Note: Sealer will not turn ON until you press
arm down.
4.
After red light turns off, wait for seal to cool,
then raise arm, and remove bag.
5.
Check seal.
— If sealer leaves a 2-3mm wide band across
bag, dial setting is correct.
—If sealer does not leave an evenly melted
band across bag, see Troubleshooting.
Cleaning/Maintenance
1.
DISCONNECT MACHINE FROM POWER!
2.
Use eraser, dry cloth, or finger to remove
residue from Teflon strip and rubber strip on
arm. Do not use solvents.
Service
If the Teflon strips become torn, replace them and
the heating element.
To replace Teflon strips and heating element:
1.
DISCONNECT MACHINE FROM POWER!
Electrical Schematic
-2-
FIgure 5. Model T26691-92 electrical schematic.
2.
Remove front cover and push forward on ter-
minal assembly to release heating element
(see Figure 4).
Metal
Plates
Teflon
Strips
Figure 4. Components that must be removed
when replacing Teflon strips or heating element.
3.
Install new Teflon strips and heating element.
Place element between strips, then reinstall
metal plates.
Troubleshooting
•
If sealer creates a partial seal, select a higher
dial setting to increase heating time.
•
If sealer melts through bag, or if bag sticks to
Teflon strip, select a lower dial setting.
•
If bag sticks to rubber strip on arm, hold arm
down longer after red light switches off to
increase cooling time.
If you need help with your new heat sealer, call
our Tech Support at: (570) 546-9663.
Heating
Element
Front
Cover
T26691-92 (Mfd. 10/14)
Advertisement
