Advertisement
4.5.2.
the detergent dispenser is similar to that described in section 4.4. When using the detergent system with the brush, keep the empty
bottle on the nozzle (fig.5.C) in place and turn the control lever (fig.5.D) to the 'off' position.
4.5.3.
Fill the brush bottle and fit as in 4.4.2., turn the control wheel (fig.7.B) to release the detergent.
5. baTTerY care
5.1.
Charge battery fully before first use.
5.2.
Always keep the battery fully charged; recharge after each use.
5.3.
if the machine is not in regular use, it is recommended that the battery is charged at least every 3 months.
5.4.
To charge the battery, insert pin jack into the socket below the selector switch (fig.4) and connect the charger to a 230V mains supply.
6. MaINTeNaNce
6.1.
the pump unit does not require any regular maintenance.
6.2.
The 12V connector lead is fitted with an 8A fast blow cartridge fuse in the accessory socket. If blown, replace with identical fuse.
6.3.
should the nozzle become blocked, run the nozzle cleaning tool through gently to remove any deposits.
6.4.
When disconnected from the hose, the nozzle can be back-flushed with either water or air to dislodge any blockage.
6.5.
When not in use drain the machine, remove hoses and store in a cool yet frostproof location beyond the reach of children.
parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
battery removal
remove 4 screws located on bottom of base, remove cover to access battery. slide out battery and disconnect. dis-
pose of battery in an environmentally protective way.
under the Waste Batteries and accumulators regulations 2009, Jack sealey ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered wih Valpak's
registered compliance scheme. Jack sealey ltd's Batteries Producer registration number (BPrn) is BPrn00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpOrTaNT: no liability is accepted for incorrect use of this product.
warraNTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
fig.3
fig.6
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7ar
Original Language Version
fig.4
fig.5
01284 757500
01284 703534
PW1712 | issue 1 08/05/17
fig.7
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
