Table of Contents
Advertisement
Quick Links
LiteWizard™
Installation Manual
AMSE Code Compliant device listed to Canadian and US standards by TUV for use in elevators.
Certified Product: Elevator PLC
Certificate Number: CU 72101368000
REV : 8.0
DATE: 1/5/2018
MANUAL NUMBER : 13
Electronic Controls Inc
7073 North Atlantic Ave
Cape Canaveral, FL 32920
WWW.ECIAMERICA.COM
800-633-9788
Advertisement
Table of Contents
Summary of Contents for ECI LiteWizard
- Page 1 LiteWizard™ Installation Manual AMSE Code Compliant device listed to Canadian and US standards by TUV for use in elevators. Certified Product: Elevator PLC Certificate Number: CU 72101368000 REV : 8.0 DATE: 1/5/2018 MANUAL NUMBER : 13 Electronic Controls Inc 7073 North Atlantic Ave Cape Canaveral, FL 32920 WWW.ECIAMERICA.COM...
- Page 2 LiteWizard™ Installation Manual DATE DESCRIPTION 7/18/2010 Initial Release 9/23/2010 Update 12/9/2010 Added Safety info and redesigned manual 2/4/2011 Added more info on CabLite product 4/8/2011 Rearranged Table of Contents page, added line about detailed installation instruction page 7 5/11/2011 Added line about fire service on page 10...
-
Page 3: Table Of Contents
Conventions Used ..........................4 Safety Information ..........................5 System Overview ..........................6 Connections ............................6 Power ............................6 Inputs............................. 6 Outputs ............................6 LiteWizard™ Configuration ......................7 7.4.1 Option Switches ........................7 7.4.2 Input Voltage ........................7 7.4.3 Timer Adjustments ........................ 8 7.4.4... -
Page 4: Warnings And Disclaimer
LiteWizard™ Installation Manual 2 Warnings and Disclaimer Thank you for purchasing equipment from ECI America, Inc. We want your new equipment to operate safely. Anyone who installs or uses this equipment should read this publication (and any other relevant publications) before installing or operating the equipment. -
Page 5: Safety Information
LiteWizard™ Installation Manual When you see the “exclamation point” icon in the left-hand margin, the paragraph to its immediate right will be a warning. This information could prevent injury, loss of property, or even death in extreme cases. Any warning in this manual should be regarded as critical information that should be read in its entirety. -
Page 6: System Overview
LiteWizard™ Installation Manual 6 System Overview LiteWizard™ is an application that runs on an ECI PLC-1 programmable logic controller. LiteWizard™ will switch off the cab lighting and fan when the car is sitting idle for a certain amount of time. Elevator safety code section ASME A17.1-2007 Section 2.14.7.2.2 defines conditions under which cabs can be... -
Page 7: Litewizard™ Configuration
7.4 LiteWizard™ Configuration 7.4.1 Option Switches There are 6 configuration switches on the LiteWizard board. See Figure 1- LiteWizard Circuit Board. Each switch pertains to one of the inputs. If the input is used the associated switch number must be in the ON position. -
Page 8: Timer Adjustments
LiteWizard™ Installation Manual INPUT TERMINAL PINS OPTION SWITCH 1, 2 9,10 11,12 7.4.3 Timer Adjustments There is one potentiometer (TIMER 1 and TIMER 2) associated with each relay (RELAY 1 and RELAY 2). Use these to adjust the time delay from the time all inputs are valid to power being turned off. -
Page 9: Installation Example
LiteWizard™ Installation Manual o In approximately 5 seconds (with TIMER POTs turned completely counter-clockwise) the relays on the board should energize. • Remove or make one input invalid o The relays should de-energize right away. • Adjust the timer(s) to the desired time remembering that with TEST LED on the times are 10% of the actual operating time.