Filling Your Unit - Whitehall Thermalator LT-4 Instructions For Operation And Care

Instructions for Operation and Care of Little Therm Compact Thermalator
3- Place the thermal packs in a large plastic, stainless
steel or enamel container (do not use aluminum).
DO NOT use the Thermalator for presoaking
packs.
4- Fill the container with enough tap water to
completely cover the Thermal Packs.
5- Soak the packs for two hours minimum, more is
recommended. If the presoak water turns cloudy,
change the presoak water and soak packs again.
Repeat until water is clear.
6- Turn packs to upright position. The packs are now
ready to use.
The Thermalator is to operate only in ambient
temperatures of 5ºC to 40ºC.
1
Make sure the unit
is unplugged and
all packaging has
been removed.
3
Place the wire rack
inside the unit. Be
careful of the
heating element.
4
WHITEHALL MANUFACTURING • P .O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com

FILLING YOUR UNIT

2
Fill unit about 3/4
full with tap water.
4
Put the Pre-Soaked
Thermal Packs on
the wire rack. Place
all the blue or white
tabs up.
Turn the packs to
upright as shown
3/4