148mmL x 210mmD
ATL425CE
This lamp is supplied with a 5W LED bulb
that provides equivalent light output of
a 35watt incandescent, but lower energy
consumption.
The LED bulb can if desired be replaced
with up to 35watt halogen incandescent
bulb, but the lamp will run hotter.
WARNING! THE LAMP WILL GET
HOT IN USE; AVOID CONTACT WITH
THE HOT LAMP, ESPECIALLY DIRECT
CONTACT WITH THE BULB.
BULB FITTING TOOL
A Suction cup tool is provided to assist in
fitting bulbs, as it is difficult to grasp the
bulb once positioned in the lamp body.
1 Press the suction cup onto the
face of the GU10 bulb.
2 Then you can use the suction cup as
a handle to insert or remove the bulb
from the lamp base.
3 Remove the tool from bulb by lifting the
edge of the cup to release.
4 Keep the tool in a safe place so that
you have next time a bulb needs
replacement.
5 CAUTION! Do not use tool on hot
bulbs. Remove tool before operating
light fixture.
NOTE: The exact type of suction cup tool
may vary from the one shown here.
LED
CHROME
CLAMP LAMP
5W
IMPORTANT: PLEASE READ THESE INSTRUCTIONS
TO FIT / CHANGE THE BULB
To fit bulbs into lamp bases - using the
fitting tool align the pins with holes in
the lamp base, locate and rotate
clockwise to engage. Remove the fitting tool.
GU10 BULB
CAREFULLY BEFORE FIRST USE.
CPIN002778
ATL425CE
1
/
turn
4
SUCTION CUP
Need help?
Do you have a question about the ATL425CE and is the answer not in the manual?
Questions and answers