Table of Contents
Advertisement
Quick Links
Contact Clamshell
Owner's Manual
Models
CCSE12
This manual includes material related to installation,
use , cleaning, and care. Exploded view(s), as well
as any available parts list(s) and wiring diagram(s)
pertaining to the unit(s) covered by this manual are
also included.
This manual must be read and understood by all
persons using or installing this appliance. Contact
your Lang dealer if you have any questions concerning
installation, use, or maintenance of this equipment.
DO NOT DISCARD THIS MANUAL.
One [1] CCSE12
contact clamshells
mounted on
a 24-inch
griddle.
2M-W2121
Rev. Q
10.2018
•
•
Advertisement
Table of Contents
Related Manuals for Lang CCSE12
Summary of Contents for Lang CCSE12
- Page 1 This manual must be read and understood by all persons using or installing this appliance. Contact your Lang dealer if you have any questions concerning installation, use, or maintenance of this equipment. DO NOT DISCARD THIS MANUAL. One [1] CCSE12...
- Page 2 Lang or a Lang-authorized service agency. or water connection. Lang is not liable for any unit which has been mishandled, abused, misapplied, subjected to chlorides, harsh THIS WARRANTY IS SUBJECT TO ALL LISTED CONDITIONS.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Warranty Specifications General Information and Installation 1–2 Control Box Wiring Daily Operation / Cleaning Troubleshooting Wiring Diagram Parts List Exploded Views 8–9 PTFE Sheet Installation... -
Page 4: Specifications
SPECIFICATIONS ADDITIONAL INSTALLATION INFORMATION Dimensions are expected changes when mounted to griddle. For information on griddle Two [2] CCSE12 mounted on dimensions, refer to the spec sheet for that griddle. A griddle will support one [1] hood 124THE griddle shown. - Page 5 SAFETY SYMBOLS These symbols are intended to alert the user to the presence of important operating and maintenance instructions in the manual accompanying the appliance. THOROUGHLY INSPECT YOUR UNIT ON ARRIVAL This unit has been tested for proper operation before leaving our plant to ensure delivery of your unit in perfect condition.
-
Page 6: General Information And Installation
Lang manufacturing is not responsible for injury, damage, loss or other claim that may occur to person or property from improper alteration, modification, addition, operation, maintenance or service, whether it be mechanical, electrical, or otherwise, which may occur from such improper alteration, modification, addition, operation, maintenance or service to this piece of equipment. -
Page 7: Control Box Wiring
CONTROL BOX WIRING 1. Run the control box wiring through the tray. The end of the control box wire with the circular connector should extend from the rear side. 2. Loosen the two bolts under the griddle on the stabilizer that line up with the slots in the tray. Slide the tray into place and tighten bolts. -
Page 8: Daily Operation / Cleaning
LOCKOUT PROCEDURE DAILY USE The unit should be allowed to preheat for approximately USE THIS PROCEDURE WHEN PERFORMING ANY 30 minutes in the up position prior to use. After this period, SERVICE OR REPAIR TO ENSURE THE SAFETY OF the unit will be ready for use until powered down. ALL PERSONNEL ON SITE. -
Page 9: Troubleshooting
TROUBLESHOOTING ERROR CODES The control can display codes based on perceived faults in the system. It should be noted, proper diagnosis is still required as these codes are meant to show how or where a malfunction has been detected, not necessarily what is causing the malfunction. i. -
Page 10: Wiring Diagram
WIRING DIAGRAM... -
Page 11: Parts List
PARTS LIST Side references are from the operator's point-of-view—from the front of the unit. Items labeled “NS” are non-serviceable. Items labeled “NP” are not pictured. All quantities are per single clamshell hood or per electrical connection in the case of parts 50, 51, 53, and 54. Other parts, such as a mounting frame, will need to be purchased with the griddle and clamshell also. -
Page 12: Exploded Views
MAIN BODY Models After 10/2018... - Page 13 HANDLE/ARMS and CONTROLLER SK2930,...
-
Page 14: Ptfe Sheet Installation
CCSE12 Contact Clamshell PTFE Non-Stick Sheet Kit CCSE12C-10NS Installation Instructions PTFE Non-Stick Sheet Installation BE CAREFUL DURING INSTALLATION. IF THE GRIDDLE AND/OR CLAMSHELL HAVE BEEN IN OPERATION, THEY AS WELL AS THE MOUNTING CLIPS FOR THE PTFE WILL BE VERY HOT AND SHOULD BE HANDLED/TOUCHED WITH CAUTION AND PROPER PROTECTION. - Page 15 NOTES...
- Page 16 LANG MANUFACTURING www.langworld.com • Printed in the U.S.A. • 2M-W2121 • Rev. Q • 10.2018 265 Hobson St. • Smithville, Tennessee 37166 Specifications are subject to change without notice. Telephone 314 678 6315 Fax 314 781 3636 •...
Need help?
Do you have a question about the CCSE12 and is the answer not in the manual?
Questions and answers