unios Linear Eclipse G2 Cloud Quick Start Manual

Cutting Guide
+
Standard RGB
+
B
-
R
G
Model: IP20, IP67
(ECM0XXXX.FPXX, ECM7XXXX.FPXX)
25mm
Strip Mounting
1 2
Recommended cleaning products:
Wax and grease remover, methylated
spirits, isopropyl alcohol or
surface cleaners.
Parts
2x Mounting Clips 2x Mounting Screws 2x End Caps
(per metre) (per metre) (per metre)
Additional Accessories
Linear Canopy Invisimount Midnight
Suspension Kit Diffuser
Suspension Kit
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Edition 10.9.20 | Product design and technical data may be subject to change
unios.com
Page 4/4
+
RGBW Tunable
+
W
White
B WW
G
CW
R
Model: RGB, RGBW, Tunable White
(ECM0XXXX.FPRG, ECM0XXXX.FPRW, ECM0XXXX.FPTW)
50mm
IMPORTANT: Refer to ESD Protection Section
located on page 1 before mounting strip.
3
Eclipse G2
Avoid pressing LED
too hard and/or sliding
fingers across strip.
Aluminium Channel
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Eclipse IP20 Strip Light is not protected against humidity and dust. For use in
these conditions Eclipse IP20 Strip Light must be used with a suitable extrusion or
the use of Eclipse IP67 Strip Light is recommended.
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
Eclipse G2 Cloud
Base IP20 Strip IP67 Strip Cloud CS20
Codes
ECM0XXXX ECM7XXXX -CS20XX.XX
Class III IP Rating Material
20 | 67 Aluminium
24V DC
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
ESD Protection
When Handling this product, care must be taken so that the LED strip is not
damaged. Damage due to inappropriate handling is not covered by warranty.
The following precautions must be taken:
• Ensure device is switched off and disconnected from power supply.
• During assembly/disassembly, care must be taken during handling of LED strip.
• Always ensure to discharge yourself of all charge by touching a grounded bare metal
surface or approved anti-static mat before working on device.
Twisted Sagging/Hanging
Cloud CS20 Cloud CB20
17.5
19.5
Edition 10.9.20 | Product design and technical data may be subject to change
Page 1/4
LINEAR SERIES
Cloud CB20 Cloud CU20
-CB20XX.XX -CU20XX.XX
Install Person/s
1-2
Contains parts and
assemblies susceptible to
damage by electrostatic
discharge (ESD)
Installed without Cutting outside
aluminium channel designated area
+
-
Cloud CU20
17.5
17.5
19.5 19.5
unios.com
Power
5 ~ 20 Watts
CAUTION