Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for GME AE3000
- Page 1 DIGITAL ANTENNA Digital TV Antenna AE3000 INSTRUCTION MANUAL...
-
Page 2: Table Of Contents
CONTENTS FEATURES ...........................2 SUPPLIED WITH .........................2 DESCRIPTION ..........................3 CONSIDERATIONS ........................3 INSTALLATION ..........................3 Installation and mounting hardware ..................3 Pole mounted – Centre ......................4 Pole mounted – Offset ......................6 Mast mounted ........................8 Fitting the ‘F’ connector to the free-end of the coax cable..........9 SPECIFICATIONS ........................10 STANDARD COMMUNICATIONS WARRANTY AGAINST DEFECTS ...........11 CONTACT DETAILS ........................12... -
Page 3: Description
Many modern vessels have a Targa arch which is an ideal location for GPS, radar and TV antennas. If the AE3000 is to be mounted on an arch or similar elevated flat surface, the included 350 mm (13.8”) pole mount with moulded end brackets and slope adjusting spacers can be used. -
Page 4: Pole Mounted - Centre
5. Repeat steps 3 and 4 to install the second end bracket to the other end of the pole. The AE3000 can be pole mounted using the 350 mm pole and end brackets provided. For centre mounting, 6. Two slope adjustors... - Page 5 Fig 3a – Installing the end bracket Fig 3b – Mounting the pole using slope adjustors End bracket Grub screw B Pole mount (16 mm x 6 mm) Grub screw B (16 mm x 6 mm) Allen key B End bracket Slope adjustors C Grub screw B (16 mm x 6 mm)
-
Page 6: Pole Mounted - Offset
1. Position the side bracket over the edge of the AE3000 ensuring the bracket fits into the recess The AE3000 can also be offset mounted using the at the top edge of the antenna radome (fig 6a). included side bracket along with the pole and end brackets. - Page 7 Fig 6b – Mounting points End bracket Offset mounting Bolts x 3 (20 mm x M5) Side bracket Centre mounting bolts A Antenna socket Power LED (35 mm x M5) Fig 6c – Cable assembly Fig 6d – Connecting the cable to the antenna ‘F’...
-
Page 8: Mast Mounted
MAST MOUNTED The AE3000 can be mounted to an existing mast adjust to small variations in mast diameters. using the side bracket and additional mast mount The cable can be run down the mast to the bracket. The mast mount bracket supports mast television receiver. -
Page 9: Fitting The 'F' Connector To The Free-End Of The Coax Cable
. Before The power injector is designed to pass power into fitting the ‘F’ connector, first route the coax towards the AE3000 from your 12 volt power source while the television. simultaneously feeding the TV signal out to your Once the cable has been routed to the television, television. -
Page 10: Specifications
Fig 10 – Installing the power injector AE3000 1 m coax cable PAL connector ‘F’ to PAL connector Power Power 10 m coax cable ‘F’ connector Fuse injector Black 12V battery or power supply SPECIFICATIONS Antenna Type: Dual loop Frequency Range: Free-to air digital television band 174 – 860 MHz... -
Page 11: Standard Communications Warranty Against Defects
Communications Pty Ltd ACN 000 346 814 (We, us, our our repairs to be free from defects in materials and or GME). Our contact details are set out in clause 2.7. This workmanship for three months from the date of the warranty statement only applies to products purchased in original repair. -
Page 12: Contact Details
Standard Communications Pty Ltd trading as GME. 17 Gibbon Road, Winston Hills NSW 2153, Australia Part Number: 310550 Drawing Number: 45923-5 A E 3 0 0 0...
Need help?
Do you have a question about the AE3000 and is the answer not in the manual?
Questions and answers