Seedo Auto Grow Home Device Quick Install Manual

Auto Grow Home Device
Quick Install Guide
Initial Installation
1. Unpack and Install Seedo
• Place Seedo close to power and if possible also
to water supply and drainage.
• Connect power cable to Seedo and plug in.
• Turn On Seedo switch (at back of device).
• Press Seedo's door opening button at top center.
• Remove all cartons, blue tapes, pink covers on
irrigator pins.
2. Install Seedo App
• Download app from App Store or Play Store.
• Read and agree to terms of use and conditions.
3. Install Seedo Consumables
• Open service door on top of Seedo.
All the installation videos are available on
the app and can be found also on Seedo's
Youtube channel.
3.1 CO2 cylinder
• Insert cylinder and turn
clockwise as far as possible.
• Do not remove cylinder after
you hear a hissing noise.
3.2 Water filter
• Remove blue cap from the filter.
• Filter is notched and can
only be inserted in one position.
• Push firmly, then turn filter
clockwise until it locks in.
3.3 Carbon air filter
• Remove the plastic filter
cover from its slot by pressing
both sides inwards.
• Insert air filter and replace
plastic cover, ensuring that
snaps are secured in place.