WAC Lighting LD-700MA03-EDIM-IS Instructions

Class 2 Constant Current Power Unit
Instructions:
CAUTION –
To reduce the risk of fire, electric shock or injury to persons:
•
Always turn off power at main switch prior to installation.
•
System intended for installation by a qualified electrician, in accordance with NEC and local regulations. Consult with
local inspector to assure compliance.
•
For use with LED loads.
Model
Input Voltage
Input Current
OUTPUT CURRENT
Port Output Voltage
Port Load
Port Load Lead Wires
Output Port
FEATURES:
•
700mA constant current for LED's optimized and stable performance.
•
Capable of supplying power to a single LED fixture.
•
Special circuit design to protect LED from high voltage pulse. driver will automatically shut off if the fixtures are not
properly wired. In this event, unplug and check the wiring and then plug it in again.
•
For use with ELV dimmer.
INSTALLATION:
1. Loosen two cover screws and remove the cover. Inside there one sets of wiring terminals.
2. Push down one set of the wiring terminals and insert fixture's red wire into the "+" terminal and the black wire into
the "-" terminal.
3. After connecting all the LED fixtures, secure the cover by tightening the two screws.
4. The product should be installed on the either internal or external surface of any indoor construction.
MOUNTING INSTRUCTIONS
LD-700MA03-EDIM-IS
120V ac,60Hz
Max 0.04A
700mA
2-4V DC
1PC 1x3W LED Fixtures
12-22AWG
1 PCS
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com