UPL-NRG S I N G L E - D E C K C A S E I n s t a l l a t i o n & O p e r a t i o n H a n d b o o k Table of Contents Energy Data............
Page 3
, the safety of our customers and employees, as well as the ongoing performance of our products, are top priorities. To that end, we include important warning messages in all Hill PHOENIX installation and operations handbooks, accompanied by an alert symbol paired with the word "DANGER", "WARNING", or "CAUTION".
Page 4
LIABILTY NOTICE For Cases with Shelf Lighting Systems Hill PHOENIX does NOT design any of its shelf lighting systems or any of its dis- play cases with shelf lighting systems for direct or indirect exposure to water or other liquids. The use of a misting system or water hose on a display case with...
Page 5
If venting does occur, the valve must not be defeated, capped, or altered by any means. WARNING: Under no circumstances should any component be replaced or added without consulting Hill PHOENIX Field Service Engineering. Utilizing improper components may result in serious injury to persons or damage to the system.
IMENSIONS 8 5/8 in [21.9 cm] 16 13/16 in [42.7 cm] 3 13/16 in [9.7 cm] 46 7/16 in [117.9 cm] 25 1/16 in 8 in [20.3 cm] 35 7/16 in [63.6 cm] [90.0 cm] 48 7/16 in [123.1 cm] 33 1/4 in [84.4 cm] 22 11/16 in [57.6 cm]...
Hill PHOENIX for your food merchandising needs. This handbook contains important technical information and will assist you with the installation and operation of your new Hill PHOENIX display cases. By closely fol- lowing the instructions, you can expect peak performance; attractive fit and finish; and long case life.
NSTALLATION MOVING CASES Hill PHOENIX display cases are generally shipped to stores with casters installed on the base frame. The cast- ers make the job of moving cases easier for everyone involved in the shipping and installation process, as well as...
Page 10
NSTALLATION TRIM OUT 1. If a master bumper is included, locate the hole in the center of the master bumper joint. Using a screw driver as a lever, slide the case-to-case joint to the center of the joint between the two cases (Fig. 2). Slide the mas- ter bumpers left or right to close the seams as required, working outwards from the center of the line-up to the ends.
C A U T I O N If any brazing is necessary, place wet rags around the area to avoid tank damage. MODEL REAR REFRIGERATION (11 3/4" OFF OF FLOOR) UPL-NRG 28 5/8 in [72.7 cm] 4 in[10.2 cm] 31 11/16 in [80.5 cm]...
MODEL DEFROST & TEMPERATURE CONTROLS UPL-NRG UPL-NRG cases are equipped with Timed-Off defrost. 1. DISCHARGE AIR The rear baffle (Fig. 5) contains the sensor bulb for tem- perature control and the discharge air probe. The defrost termination control thermostat and the temperature control 2.
& M AINTENANCE CLEANING PROCEDURES FANS A periodic cleaning schedule should be established to • The evaporator fans are equipped with 16-watt fan motors. maintain proper sanitation, insure maximum operating Motors have a counter-clockwise rotation when viewed efficiency, and avoid the corrosive action of food fluids from the shaft end.
ARTS RDERING Contact the Service Parts Department at: 1-800-283-1109 Provide the following information about the part you are ordering: • Model number and serial number of the case for which the part is intended. • Length of the part (if applicable). •...
Page 19
Material or Workmanship States Our Entire Liability Whether Based on Tort, Contract or Warranty. We Neither Assume Nor Authorize Any Other Person to Assume for Us Any Other Liability in Connection with Our Product. MAIL CLAIM TO: Hill PHOENIX Hill PHOENIX Display Merchandisers Refrigeration Systems &...
Page 20
1925 Ruffin Mill Road, Colonial Heights, VA 23834 Due to our commitment to continuous improvement, all specifications are subject to change without notice. Hill PHOENIX is a Sustaining Member of the American Society of Quality. Visit our web site at www.hillphoenix.com...
Need help?
Do you have a question about the UPL-NRG and is the answer not in the manual?
Questions and answers