Advertisement
1
A
B
Place a front wheel (A) onto the peg on the front wheel
assembly (B), making sure the word "inward" on the wheel
faces toward the center of the unit. Press rmly until the
wheel snaps in place. Repeat for the other wheel.
3
F
E
Place the pegs on the fender (F) into the slots on the fork of
the center unit (E) and press them into place. Then, press
down on the front edge of the fender until the lip of the
fender snaps into the slot in the center unit.
5
D
Lay the unit on its side and, using a hammer, tap the second
axle cap (D) onto the other end of the axle.
When using the hammer, it is important to
tap the axle cap. If the cap is placed too
tightly, the wheel will not spin.
2
ASSEMBLY
2
A
Place one axle cap (D), color side down, onto a piece of
scrap wood (not included). Using a hammer, tap the axle (C)
rmly onto the axle cap. Then, set it aside.
Always wear safety glasses when using a hammer.
4
E
Place the back wheel (G) into the fork of the center unit (E).
Slide the axle (C) through opening on the fender, wheel,
fork assembly and out the other side.
6
Place the seat onto the center unit, making sure the peg on
the underside of the seat ts in the opening closest to the
front of the rider. Press rmly until the seat snaps in place.
NOTE: To adjust the seat as the child grows, press upward on
the spring-loaded peg on the underside of the seat and slide
the seat back until the peg slips into the second opening in
the center unit.
7
C
D
SCREW OPENING
SHOULD FACE
FORWARD
Place the front opening in the center unit over the top of the
front wheel assembly, making sure the screw opening in the
assembly is facing forward. Then, press down rmly.
G
C
H
8
J
I
Place the neck of the handlebars into the opening in the
center unit and align the arrows. Then, press down until it
snaps into place. Using a Philip screwdriver (not included)
install the screw (J) in the opening on the front of the
wheel assembly.
3
Advertisement
