MGA Entertainment little tikes Pillow Racers BEE Manual page 2

ASSEMBLY
1
First, open the hook and loop fasteners under the
base and remove pillow body from both front and
rear wheel extensions and anti-tip bar on base.
3
B
Thread steering handle (B) through opening
located on the top of the pillow as shown. For
correct placement, make sure the logo on the
handle is facing the front.
5
Pull pillow body over front anti-tip bar.
2
2
Unscrew steering handle's nut from handle
and remove.
4
Be sure steering handle is completely
through opening.
6
Insert steering handle through hole in
base of the body as shown.
7
B
Secure using steering handle's nut (B) as shown.
9
10
C X4
Push wheel (C) x4 into base until it snaps in place.
8
Pull pillow body back over both front and rear
wheel extensions.
1. Pull cloth together at the LEGS and close the
hook and loop fastener.
2. Pull the cloth together at the CENTER and
close the hook and loop fasteners.
3