Briggs & Stratton InfoHub 6520 Installation And Operation Instructions Manual page 8

4. Select "Wi-Fi." The icon to the left of WiFi will change
if the wireless gateway module is already connected
to a WiFi network.
5. Put the wireless gateway module in "Wi-Fi Direct
Mode" by pushing and holding the WiFi Configuration
button (B, Figure 1) on the wireless gateway module
board for 5 seconds. The MODE LED (D, Figure 1)
will flash light blue. If the MODE LED does not flash
light blue, cycle power to the device then push and
hold the WiFi Configuration button (B, Figure 1) again
for 5 seconds.
6. Enter the mobile device's Wi-Fi settings page and
search for available WiFi networks. The WiFi settings
page will differ depending on your mobile device's
brand, type and network service provider.
Connect to the following network name:
BASCOGATEWAY-XXXXX. After selecting the
BASCOGATEWAY-XXXXX network from the mobile
device's network list, return to the app and push the
"Yes" button on the initial WiFi screen.
8
BASCOGATEWAY-XXXXX
7. You will prompted to enter the network SSID and
Password (both are case sensitive).The mobile
device will start pairing to the wireless gateway
module.
SSID
Password
After the SSID and password are entered, the user
can then send the WiFi settings to the wireless
gateway module. If successful, the MODE LED (D,
Figure 1) will be dark blue. If it failed, the MODE LED
(D, Figure 1) will be red. Please try again.
NOTICE: The user can wait approximately 2 minutes
before the connection is established. The MODE
LED (D, Figure 1) will flash dark blue momentarily
and then green when a connection is made to the
InfoHub™ Cloud.
8. Your power management device shows up as
available. In this example it is showing that a 12kW
generator is available.
9. Select "Module Set-Up." Add your Power Management
Device. Add loads by pressing the "Add New" button."
10. Press the "Join" button on all of the power
management devices (G, Figure 2 / B, Figure 3).
Follow the on-screen prompts.
BRIGGSandSTRATTON.COM