Water Dispenser Wall Installation; How To Use; Water Bottle Installation; Water Dispenser Indicator Light Panel - KYOWA KW-1514 Instruction Manual

 Keep out of reach from children or from persons with mental or physical
disabilities.
 This KYOWA Water Dispenser is intended for normal domestic/household
use only. This unit is not suitable for commercial use.

WATER DISPENSER WALL INSTALLATION

HOW TO USE

WATER BOTTLE INSTALLATION

 Remove plastic lid over the mouth of the water bottle.
 Insert hose into the water bottle then firmly press bottle cap into the lid.
(FIGURE 1)
 Reminder: The unit has a door sensor for safety purposes. It will not
function if the lower cabinet door is open.
3

WATER DISPENSER INDICATOR LIGHT PANEL

 1. HOT WATER INDICATOR (red light) –
illuminates to indicate that hot water was able to
reach set temperature; hot water is available
 2. HEATING (red light) /COOLING (blue light)
– turns ON to indicate that Water Dispenser is
currently heating up/cooling down water
 3. COLD WATER INDICATOR (blue light) –
illuminates to indicate that hot water was able to
reach set temperature; cold water is available
 4. REFILL (red light) – this light illuminates to
indicate that sensor detects low water level in
the bottle. Replace or refill water bottle then
close Water Dispenser cabinet door to reset unit;
REFILL indicator light will then turn OFF.

WATER DISPENSING FUNCTION

 Install water bottle into the Water Dispenser following the WATER
BOTTLE INSTALLATION instruction.
 Close water dispenser cabinet door, then plug unit into a wall receptacle
that is properly installed and grounded to reduce risk of electric shock.
Make sure the heating switch is turned OFF.
 When using Water Dispenser for the first time, allow at least 1 gallon of
water to come out of the HOT and COLD Water Dispenser faucets to
wash out all factory oil or dirt residues.
 Turn ON heating and/or cooling function by pressing HOT and/or COLD
buttons at the back part of the Water Dispenser. Allow Water Dispenser
to heat up or cool down water for a couple of minutes, press cup into the
cool water faucet to dispense cold water; to dispense hot water, press
safety lock then press cup into the hot water faucet simultaneously.
 For initial use, wait for about 30 minutes before dispensing hot and cold
water from the Water Dispenser.
4