Table of Contents
Advertisement
Quick Links
Warranty
This product has a three‐year limited warranty from any factory defects on parts and labor as per the KH
Industries Terms and Conditions of Sale distributed with the product invoice. The separate warranty
card should be filled out to avoid discrepancies in warranty information. Please contact KH for warranty
service (see "Contact" section) if required.
© 2013, K&H Industries, Inc. (rev 8.29.2013)
Contact KH Industries
For questions, sales or service please contact:
Phone:
Fax:
Email:
Web:
Address: K H Industries
KH INDUSTRIES
The Permanent Name in Temporary Lighting & Power
NightRay® with Wireless Remote
Instructions and Operator's Manual
716‐312‐0088
716‐312‐0028
sales@khindustries.com
www.khindustries.com
160 Elmview Avenue
Hamburg, New York 14075
USA
Advertisement
Table of Contents
Related Manuals for KH Industries NightRay
Summary of Contents for KH Industries NightRay
- Page 1 KH INDUSTRIES The Permanent Name in Temporary Lighting & Power NightRay® with Wireless Remote Instructions and Operator’s Manual Contact KH Industries For questions, sales or service please contact: Phone: 716‐312‐0088 Fax: 716‐312‐0028 Email: sales@khindustries.com Warranty Web: www.khindustries.com This product has a three‐year limited warranty from any factory defects on parts and labor as per the KH Industries Terms and Conditions of Sale distributed with the product invoice. The separate warranty Address: K H Industries card should be filled out to avoid discrepancies in warranty information. Please contact KH for warranty 160 Elmview Avenue service (see “Contact” section) if required. Hamburg, New York 14075 ...
- Page 2 Reorient or relocate the receiving antennae. Programming a Wireless Remote Increase the separation between the equipment and receiver. If your NightRay was ordered with a wireless remote, it is factory preprogrammed to the NightRay. If you Connect the equipment into an outlet on a circuit different from that which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. wish to add additional remotes or program the remote to additional NightRay units, you can program them using the following procedure: FCC CAUTION: Disconnect power from the NightRay unit. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. K&H INDUSTRIES INC. ASSUMES NO LIABILITY FOR DAMAGES RESULTING FROM MISUSE OR ABUSE OF THIS PRODUCT Press the A/B pushbutton to select either the green or red transmitter code. This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: Press and hold any UP, DOWN, LEFT or RIGHT pushbutton. (1) this device may not cause interference and Restore power to the NightRay unit. (2) this device must accept any interference, including interference that may cause undesired operation of the device. Release the pushbutton when the lamp starts to flash indicating the receiver has been ...
Need help?
Do you have a question about the NightRay and is the answer not in the manual?
Questions and answers