Advertisement
Tool Adjustment Procedures:
1
Note the number to which the line on the hex head of the back pin points.
2
Carefully remove the retaining clip (see Figure 1) by inserting a small flat blade
screwdriver in the loop of the clip and turning the screwdriver. CAUTION! The
retaining clip is made from spring steel and may fly off of the pin if not removed
carefully, possibly causing eye damage and loss of the clip.
Figure 1
3
From the clip end of the back pin, push it towards the tool body until the hex head
on the other end of the pin just clears the body.
4
Rotate the pin until the line on the hex head points to the next higher number on the
frame.
To Reduce Crimp Size,
Rotate Back Pin to Next Higher Number
5
Push the pin back into the frame and replace the retaining clip.
6
Crimp a test joint and check crimp ring for proper sizing with GO/NO-GO gauge
or measurement. Severely worn tools may require further adjustment. As the tool
continues to wear with use, simply repeat these instructions as required.
Viega Limited Warranty
The Compact Angled PEX Crimp Hand Tool
Viega warrants that the Compact Angled PEX Crimp Hand Tool will be free
from failure caused by manufacturing or design defect for a period of ninety (90)
days from date of purchase by the user of the tool.
This limited warranty does not apply: (1) if the failure is due to abuse in
handling, using, storing, or maintaining the tool; (2) if the failure of the tool is the
result of use of the tool in non-recommended application; (3) if the failure is due
to unauthorized tampering (attempted repairs or adjustments) to the tool.
THE ABOVE LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF
THE MERCHANTABILITY. Other than this limited warranty, Viega does not
authorize any person or firm to create for it any other obligation or liability in
connection with its products.
If there is a failure covered by this limited warranty during the warranty period,
such failure must be reported promptly to Viega, after such failure is discovered.
Warranty claims and questions should be directed to Viega's sales department
by writing to the address below or telephoning, toll free, 800-VIEGA-NA to
obtain a return merchandise authorization and directions on shipment. Within
a reasonable time after notification, an investigation of the claimed failure will
occur. If the conditions of the limited warranty are met, Viega will perform, free
of charge, necessary repairs and return the tool, or, if repairs are not possible, a
replacement tool will be provided. THESE ARE THE EXCLUSIVE REMEDIES
FOR BREACH OF THIS LIMITED WARRANTY.
After the expiration of the warranty period, factory repair or reconditioning of
the tool is available at a modest cost. Customers should contact Viega for
information.
NEITHER THE MANUFACTURER OF THE TOOL NOR VIEGA SHALL BE
LIABLE FOR CONSEQUENTIAL, SPECIAL OR INCIDENTAL DAMAGES
BASED UPON BREACH OF WARRANTY, BREACH OF CONTRACT,
NEGLIGENCE, STRICT TORT, OR ANY OTHER LEGAL THEORY, AND
REGARDLESS OF WHETHER ASSERTED BY DIRECT ACTION, FOR
CONTRIBUTION OR INDEMNITY, OR OTHERWISE. Such damages include,
but are not limited to, damage to property and other economic loss, but do not
include personal injury damages.
Some states do not allow the exclusion or limitation of incidental or consequential
damages or implied warranties in certain types of transactions, so the above
exclusion or limitation may not apply to you. This limited warranty gives you
specific legal rights, and you may also have other rights which vary from state
to state.
301 N. Main St. Floor 9
Wichita, KS 67202
800-VIEGA-NA (Continental U.S.) 316-425-7400 (outside U.S.)
5.08
PI-PF-41703 5/08
Purchaser's Name
Address
City
State
ZIP
Tool Purchased From
Remove Retaining
Clip
Back Pin
Viega LLC
Tool Model No.
Tool Serial No.
Date Purchased
Advertisement
