Jandy Pro Series PlusHP Series Instructions

FOR YOUR SAFETY: This product must be installed and serviced by a contractor who is licensed and qualified in pool
equipment by the jurisdiction in which the product will be installed where such state or local requirements exist. The maintain-
er must be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instruc-
tions in this manual can be followed exactly. Before installing this product, read and follow all warning notices and instruc-
tions that accompany this product. Failure to follow warning notices and instructions may result in property damage, personal
injury, or death. Improper installation and/or operation will void the warranty.
These instructions are to be used with the following Jandy Pro Series Replacement Parts:
R0448800-- Lid with Locking Ring and Seal Replacement Kit (PHPF/PHPM, WFTR, MHPM)
R0448900-- Pump Debris Trap Basket Replacement Kit (PHPF/PHPM, WFTR, MHPM)
R0449100-- Lid Seal and Lid O-ring Replacement Kit (PHPF/PHPM, WFTR, MHPM)
Before servicing the pump, be sure to switch off the circuit breaker to the circuit supplying electrical power to the pump. Failure
to do so could result in property damage, severe personal injury, and/or death.
Parts List
Description
Lid with Locking Ring
Lid O-ring
Pump Debris Trap Basket
Lid Seal
Instructions
NOTE The Lid Seal has
a three-lobed cross section
and the Lid O-ring has a
round cross section.
Lid with
Locking Ring
and Seal
R0448800
Pump Debris
Trap Basket
R0448900
Figure 1. Exploded View of PHP, WFTR, and MHP Pump Parts
PHPF/PHPM, WFTR, and MHPM Pumps, Lid w/
Locking Ring and Seal, Lid Seal and Lid O-ring,
and Basket, Replacement Kit Instructions
1
-- --
--
-- 1
--
1 --
1
-- 1
1
1 1
Lid Seal & Lid O-ring
R0449100
Lid Seal Lid O-ring
WARNING
WARNING
1. Introduction
This document contains instructions for the prop-
er replacement of the lid with locking ring and seal, the
lid seal or lid o-ring, and the pump debris trap basket on
Jandy Pro Series PlusHP (PHP, Models PHPF/PHPM),
Water Features (WFTR) and MaxHP (MHP, Model
MHPM) Pumps.
These replacement kits are designed to be used
with both newer and older model Jandy PHP, WFTR,
and MHP Pumps. Refer to Figure 1 and the parts list on
this page to identify the parts in each kit.
These instructions must be followed exactly.
Read them completely before starting the procedures.
Align the slot of the basket with the
position tab inside of the pump body.