Table of Contents
Advertisement
196
If Something Goes Wrong
Develop good computing habits
5
6
Cannot use the "USB Sleep and Charge function."
(Available on certain models)
❖
The setting of "USB Sleep and Charge function" may be
Disabled. Change the setting to Enabled.
❖
Some external devices may not be able to use the "USB Sleep
and Charge function". In this case, please try one or more of
the following methods.
❖
❖
❖
If this function cannot be used, change the setting to Disabled.
❖
Make sure that you are connected to a compatible port.
The "USB Wakeup function" does not work.
❖
When the "USB Sleep and Charge function" is Enabled in the
TOSHIBA Hardware Setup, the "USB Wakeup function" does
not work for ports that support the "USB Sleep and Charge
function." In that case, use a USB port that does not have the
"USB Sleep and Charge function"-compatible icon ( ), if you
have a non-Sleep and Charge USB port available or disable the
"USB Sleep and Charge function" in TOSHIBA Hardware
Setup.
The eSATA device is not recognized from Sleep or
Hibernation mode.
A connected eSATA device may not be recognized if it is connected
to the computer's eSATA/USB combo port while the computer is in
Sleep or Hibernation mode. If this occurs, disconnect the eSATA
device and then reconnect the device while the computer is turned
on.
Use the new hardware or software for a while, noting any
new problems. Make sure that your critical applications (e-
mail, business applications, etc.) are working correctly,
and verify that important devices are still functioning.
For each additional hardware or software item, repeat
these steps, starting at step 1 if any of your critical data has
changed, or starting at step 2 if no critical data has
changed.
Change the Enabled mode setting.
Turn OFF the computer while external devices are
connected.
Connect external devices after turning OFF the computer.
Advertisement
Table of Contents
