Warm4Less Xenon Operating Instructions

Xenon – RF Receiver Operating Instructions
Specification:
• Power source: 100-240VAC 50/60HZ
• Wireless Signal Frequency: 868MHZ (FSK)
• Wireless signal Range: 100m
• Accuracy + 1°C
• Ambient Temperature Operation: 0°C – 50°C
• Dimensions: 86mm x 86mm x 24.4mm
Safety Information:
• Always turn off power at the main power source by unscrewing fuse or switching off
the circuit breaker before installing, removing, cleaning or servicing this thermostat.
• Read all of the information in this manual before installing this unit.
• Only a professional contractor should install this unit.
• All wiring must conform to local and national building and electrical codes.
• Only use the thermostat as described in this manual.
Mounting the receiver:
1. Remove the back board of the receiver by unscrewing the screw at the bottom.
Some units may vary and may not have screws on the bottom, if not gently pull the
back off, please be careful when doing this as it may cause damage to the unit.
2. Connect the wires beneath the terminal screws to a power supply module using an
appropriate wiring schematic.
3. Push the back of the unit into a 86mm x 86mm surface box.
4. Using the mounting screws provided, mount the back of the unit onto the wall in the
surface box. Place a level against the base of the unit to ensure the unit is straight.