Replacing The Rotor - Toro Power Curve 1800 Operator's Manual

1. Screws
2. Remove and discard the old scraper.
3. Install the new scraper, and fasten it securely with the 4
screws that you previously removed.

Replacing the Rotor

1. Remove the screws that secure the right side plate to the
machine frame (Figure
2. Remove the rotor pin
1. Rotor pin
Figure 14
15).
Figure 15
(Figure 16).
Figure 16
3. Remove the old rotor.
4. Install the new rotor by inserting the end of the rotor onto the
fitted end in the housing and rotating the rotor until it snaps
into place (Figure
g013469
1. Fitted end of the rotor
Note:
Ensure that the nut that secures the rotor pin
remains inside the recessed hole in the right inside wall of
the housing.
Note:
The housing will flex when you install the rotor.
5. Tighten the bolt on the side of the housing.
6. Install the right side plate with the screws that you removed
in step 1.
g013463
g013464
9
17).
Figure 17
g013465