Advertisement
Maintenance methods
Please perform a maintenance carefully.
Please do not use diluent, volatile oil, flammable substance, alkaline detergents, bleachers, etc.
(protects against discoloration, deformation, cracking, etc.)
A current product can be rinsed, avoid a direct sunlight on it after rinsing, dry thoroughly before using
The stains on the product can be rinsed off with a water, in a serious situation
can use a detergent that should be washed out immediately.
To not to cause a malfunction, please avoid a soak cleaning.
Dry the moisture from inside on the upper cover before re-assembling and storing.
Methods of disassembling and
installing of eddy current fans and
countercurrent fans.
Fixed nut
16
Fixed nut
Sealing gum cushion
When the sealing gasket inside the bottom cap is falling off, it
should be reloaded, please note that it is not distorted, misplaced
and uplifted.
About small sucking tube
Storage methods
In order to prevent a malfunction and decrease of suction after using it, please keep it
in a storage as follows.
Set the water switch to the water spray position 「 」.
Wipe off the moisture on each part and store it.
There is a possibility of breeding mold and bacteria if it is stored in a water vapor storage.
中性洗涤剂
Pay attention please
Neutral detergent
Be aware from problems
Please check the following in case a malfunction occurs while using this product.
Phenomenon
The
absence
of
clear water and its
deficiency
A water leak
Abnormal sound
and vibration
A suction reduction
of the vacuum
cleaner
Cause
Wheather the water switch (a non water-jet) position is on an upward side「
Is the bottom of the product body and the suction inlet lifted from the cleaning surface?
Put down the main body and the suction inlet of the product, keep close to the stain and
start cleaning the front by sliding movements.
Whether the air-in regulating switch widely open?
Whether the air intake of the suction inlet part clogged up?
Is the extension tube inserted?
Is the vacuum bag or cup for dust clogged? Is it overfilled by dust?
Does an overload protection device operating well?
Does the overload protection of the vacuum cleaner work?
Please refer to instructions for handling a troubleshooting.
Is the small sucking tube coming off?
Has it been tipped over with a water inside of tanks?
There might be a water leak inside of a product's body.
If the bottom head was not turned tightly?
Are the eddy-current fan and the counter-current fan not installed properly, and the nuts
are not turned tightly?
Did the reset proceed after the backflow valve has been triggered?
Is there a hair or a fiber dust on a turbofan and a counterflow?
Please carry out a maintenance.
Please adjust an air-in regulating switch and an intensity speed setting of the vacuum cleaner. 12
Is the vacuum bag or cup for dust clogged? Is it overfilled by dust?
Please refer to the instruction manual for cleaning.
The switch for clear water
Ref.page
」?
8 ・ 13
6・13
8・12
7
10・11
–
–
16
–
7・9
16
12
16
–
17
Advertisement
