CDB iGlo Quick Manual

INSTALLATION GUIDE:
INSTALLATION:
CAUTION:
•
Ensure all packaging materials are fully removed prior to installation.
•
Unravel the strip light fully.
1) Select the appropriate mounting position, make sure the power supply can be plugged in without
excessive tension on the cable.
2) Clean the surface thoroughly to ensure maximum adhesion, make sure it is dry prior to
installation.
3) Measure and cut the LED strip to the correct length (if required), be careful no to cut the wrong
end. Review the product carefully prior to cutting, only one end allows the power supply to be
connected.
4) Remove the backing tape gradually while applying the strip light to the surface. Apply in short
lengths to minimise mistakes. Do not use excessive pressure to attach the strip light to the
surface.
5) Once fully applied connect the power supply using the pin connectors on each end of the light
and power supply. Complete this process carefully to avoid any damage.
6) Plug into a wall socket and turn the switch 'ON'.
7) Your light is now ready to use.
SMART FEATURES (COLOUR CHANGE, DIMMING ETC):
This product can be controlled by either a remote or via the Smart Lighting App (in the case of the Wifi
enabled model). Please read the iGlo user manual (enclosed in box) for detailed operating
instructions.
5M LED STRIP LIGHT