ZipKord ROCKZ ZKPBK1055 Operator's Manual

5000mAh POWER BANK
Integrated Lightning™
& Micro-USB Cable
OPERATOR'S MANUAL
Model #: ZKPBK1055
Contents
5000mAh Power Bank
Operator's Manual
Please read in its entirety prior to use
Charging the Power Bank:
1) The Power Bank can be charged by plugging
the integrated USB-A cable into an USB
charger that plugs into an AC outlet, DC car
power port, or powered USB port.
2) The Power Bank's blue LEDs will illuminate
in sequence and blink while charging. Upon
completion, the LEDs will remain
illuminated signaling a complete charge.
Note: The approximate charging time for the
Power Bank is 2-4 hours from an AC outlet
and up to 6 hours from a computer or other
power source.
WARNING: Safe operating temperature range
is 32°F - 100°F. DO NOT EXCEED THE
RECOMMENDED SAFE OPERATING
TEMPERATURES. Charging in environmental
temperatures greater than 100°F may degrade
performance; reduce the life of the battery;
cause the product to overheat or fail and may
result in a risk of re, explosion and potential
bodily injury or property damage.
Charging Your Device:
1. Fully charge the Power Bank before use.
2. Connect the Lightning™ cable to the
Lightning™ port of your mobile device and
charging will begin immediately.
3. Connect the Micro-USB cable to the
Micro-USB port of your mobile device and
the charging will begin immediately.
4. The blue LEDs will blink to indicate
charging and to display the remaining
battery life.
5. Use care when extending the charging
cables to avoid damage or breakage. The
cable should be slack while connected to
your device. Never allow your device to
hang from the charging cables.
6. Do not force the cable connectors when
plugging into a device – they should
connect easily with minimal effort. Forcing
connectors may cause damage to the
Power Bank or your mobile device and may
invalidate your Limited Liability Warranty.
7. For best results, be sure to recharge your
Power Bank after charging your devices.
Failure to use the Power Bank provided
equipment properly may cause the product
to fail or overheat, in certain
circumstances, resulting in a risk of re,
explosion and potential bodily injury or
property damage.