Gianni Industries Indoor Series Installation Instruction

Optional Bracket
Bracket installation is according to door swing direction and door frame type ,e. g. narrow frame door , frameless glass door, inswing door , etc.
Regular Installation
(outswing door)
Regular Installation
1
Tem pl ate
2
3
4
Armature Plate
Hollow Metal Door
Outdoor
Outdoor
12.7mm 8mm
6.8mm for M8-1.25 thread
Drill a Ø8mm hole through
Drill a
d o o r, o n c l o s i n g s i d e and tap on closing side
enlarge to Ø12.7mm by a a M8x12.5 thread.
sexnut blot on the opening
side.
Recommendation:
For Micro EM-locks (300 LBS), maximum thickness of door is 44 mm.
For Mini EM-locks (600 LBS), maximum thickness of door is 50 mm.
For Midi EM-locks (800 LBS), maximum thickness of door is 48 mm.
For Maxi EM-locks (1200 LBS), maximum thickness of door is 46 mm.
Copyright © Gianni Industries, Inc. All rights reserved.
P-MU-AM-EM Ver. I Published on: 2011.04.07
Electromagnetic Lock
(Indoor Series)
L-bracket for narrow
frame (optional)
Fold the mounting template 90°
Place the template to the proper
position of the door and frame. Mark
the hole positions of the template on
the door and frame.
Drill the holes according to the
marks.
Please install the armature plate as
illustrated here. (Dimensions of the
holes are depending on the door
types as illustrated below.)
Reinforced Door Solid Door
36mm
Outdoor
12.7mm 8mm
Ø6.8mm hole Drill a Ø8mm hole thrugh
d o o r o n c l o s i n g s i d e
enlarge to Ø 12.7mm, by a
sexnut blot on the opening
side. The depth is 36mm.
Installation Instruction
U-bracket for frameless
glass door (optional)
5
Rubber Washer
6
7
Cable
8
Allen wrench
Power
9
Outdoor
LZ-bracket for inswing
door (optional)
T h e r u b b e r w a s h e r m a k e s t h e
s u r f a c e o f t h e a r m a t u r e p l a t e
adjustable in order to completely fit
the surface of magnetic lock.
Fasten the mounting plate with the
mounting screws. The position of the
mounting plate should be adjustable.
Fix the mounting plate on the door
with mounting screws
Use the Allen wrench and fixing bolts
to tighten the electromagnetic lock to
mounting plate.
Connect the power and test the unit.