Advertisement
4.2.
OPERATING REQUIREMENTS
4.2.1.
For maximum performance and rated hydraulic pressure, air pressure should be 100psi minimum.
4.2.2.
To ensure best performance the air supply equipment should include an air filter, regulator and lubricator. A minimum
requirement is an air filter with the air compressor tank drained of water every day and a small quantity of lubricating oil into the air
inlet each week.
4.2.3.
Hydraulic output pressure can be controlled by regulating the air pressure. To determine the maximum hydraulic pressure multiply the
regulated air pressure reading by 100.
5. MAINTENANCE
5.1.
RELEASE VALVE ADjUSTMENT
5.1.1.
Attach an air supply to the pump.
5.1.2.
With a hex key loosen socket headed cap screw (Fig.2.) in treadle pivot boss two or three full turns.
5.1.3.
With a screwdriver turn anti-clockwise the slotted head release valve (Fig.2. and Fig.3.) two full turns.
5.1.4.
Lift the treadle at the air inlet end and depress the air valve button (Fig.1.) with your thumb.
5.1.5.
Actuate the pump to build up pressure in the hose by depressing the treadle on to thumb and depressed air valve.
5.1.6.
Using a screwdriver turn the slotted head release valve clockwise gently until resistance of the valve seat is felt. Excessive tightening
will cause loss of pressure in hose.
5.1.7.
Continuing to depress the air valve button with your thumb to obtain operating clearance between the treadle air valve and the release
valve, tighten socket headed cap screw with a hex key through treadle pivot boss.
5.1.8.
Release valve should now be correctly set.
Air valve button
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN PRODUCT TO US. Please telephone us on 01284 757500 to obtain the address and phone number of your local agent.
If product is under guarantee please contact your dealer.
De-commissioning Product
Should the product become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of the product
and the oil according to local regulations.
.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.1
Socket head cap screw
01284 703534
Original Language Version
Oil filler plug (on underside)
Release valve
fig.2
sales@sealey.co.uk
RE83/840.V2, RE83/840/CWH.V2 | Issue:3 (H,F) 25/06/19
fig.3
www.sealey.co.uk
Advertisement
