Advertisement

Quick Links

Technical Supplement
Reporter

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Reporter and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Aqua-Hot Reporter

  • Page 1 Technical Supplement Reporter...
  • Page 2: Table Of Contents

    House Power Sense ..............5 600D ..................28 Connecting the 100D to 12V DC Power .......5 Power Inputs, Pumps, & Safeties ........28 Connecting the Aqua-Hot to AC Power .........5 Burner ................. 29 Testing ..................5 Electric Elements & High-Limit T-Stats ......30 Introduction ................5...
  • Page 3: The Aqua-Hot Reporter

    The Reporter is used across the 400, 450, 600, and 675 units. The previously used electronic control board has been retired on new units in favor of the Reporter. There are two series of Reporters presently in use: Reporter 1.0 and Reporter 2.0.
  • Page 4: Heartbeat Function

    Aqua-Hot can be activated independently from other elements for their functionality to be verifi ed. There is a slot located at the bottom of the Reporter which serves as access for the harness and power connections. Take these into consideration when choosing the mounting location for the Reporter.
  • Page 5: Boost Pumps

    Reporter 2.0. Zone Fans 2-5 (Reporter 2.0).........5.0A max Zone Fans (all)............0.25A max On Reporter 1.0 units, any boost pumps at use within the Circulation Pumps (each)........2.0A max coach required a relay connected to wires 3b and 5b in order AC Relay..............0.5A max...
  • Page 6: Filling And Purging The Aqua-Hot

    11. Once the air is no longer returned from the heating zone return ports, deactivate the fl uid circulation pumps. 1. Locate the fl uid drain port of the Aqua-Hot. This is located 12. Open the fl uid drain valve, and activate the external at the front of the unit near the bottom of the tank face.
  • Page 7: Fault Conditions

    Please note, that if the responsible component is activate. Keep in mind that these testing screens will ignore input from the fl uid level sensor. On Reporter units with fi rmware not repaired or replaced, it can continually cause over-current...
  • Page 8: Fans

    The J1 plug manages heating Figure 13 zone inputs from the coach. Diagnostic The “DIAG” tab of the Reporter allows the user or technician to access input and output information to record communication information within the Aqua-Hot heater, and Figure 16 between the heater and the coach.
  • Page 9 Zone Fan 1 (Switched 12V+) J3 serves as the RVC connection to the coach- side comfort system (if applicable). The RVC indicator light located on the back of the Reporter serves as a valuable diagnostic tool when the need to determine RVC functionality arises.
  • Page 10 Zone 2 Boost Pump (400 Series) Pump 4 Output (12V DC+) 600/675 Only Pump 4 Ground 600/675 Only Electric Element On-Signal AC Ground Burner Ground Diesel Burner Status Input Figure 22 p. 8 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 11: Manual Mode (Reporter 2V9)

    RVC network to aid in the Aqua-Hot’s integration into the on- additional 3 days. board RVC network. There is an indicator light on the back of the Reporter which shows the current status of the Reporter’s connection to the RVC network. This will be useful when diagnosing potential problems with the coach-side RVC network.
  • Page 12: System Schematics

    Fluid Expansion Bottle 400D 400D p. 10 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 13: Burner

    Fluid Expansion Bottle 400D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 11...
  • Page 14: Electric Elements & High-Limit T-Stats

    Installing Heat Exchangers 400D p. 12 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 15: Switch Panel

    Locations and Clearances 400D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 13...
  • Page 16 Plumbing the Heating Loop 400D p. 14 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 17: Heating Zones

    Plumbing the Heating Loop 400D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 15...
  • Page 18: 400P

    Wiring Heat Exchangers 400P 400P p. 16 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 19: Burner

    Domestic Water System 400P ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 17...
  • Page 20: Electric Elements & High-Limit T-Stats

    Mounting the Aqua-Hot LCD 400P p. 18 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 21: Switch Panel

    Mounting the Aqua-Hot LCD 400P ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 19...
  • Page 22: Heat Exchangers

    Mounting the Aqua-Hot LCD 400P p. 20 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 23: Heating Zones

    Confi guring the Zones 400P ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 21...
  • Page 24: 450D

    House Power Sense 450D 450D p. 22 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 25: Burner

    Providing DC Power 450D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 23...
  • Page 26: Electric Elements & High-Limit T-Stats

    Providing AC Power 450D p. 24 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 27: Switch Panel

    Filling the Aqua-Hot 450D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 25...
  • Page 28: Heat Exchangers

    Purging the Heating Loop 450D p. 26 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 29: Heating Zones

    Purging the Heating Loop 450D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 27...
  • Page 30: 600D

    Purging the Heating Loop 600D 600D p. 28 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 31: Burner

    Purging the Heating Loop 600D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 29...
  • Page 32: Electric Elements & High-Limit T-Stats

    Purging the Heating Loop 600D p. 30 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 33: Switch Panel

    Purging the Heating Loop 600D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 31...
  • Page 34: Heat Exchangers

    Purging the Heating Loop 600D p. 32 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 35: Heating Zones

    Purging the Heating Loop 600D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 33...
  • Page 36: 675D

    Purging the Heating Loop 675D 675D p. 34 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 37: Burner

    Purging the Heating Loop 675D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 35...
  • Page 38: Electric Elements & High-Limit T-Stats

    Purging the Heating Loop 675D p. 36 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 39: Switch Panel

    Purging the Heating Loop 675D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 37...
  • Page 40: Heat Exchangers

    Purging the Heating Loop 675D p. 38 ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement...
  • Page 41: Heating Zones

    Purging the Heating Loop 675D ©Aqua-Hot® Aqua-Hot Reporter Install & OEM Supplement p. 39...
  • Page 42 SERVICE & OEM SUPPLEMENT Reporter Aqua-Hot Heating Systems, LLC 7501 Miller Drive, Frederick, CO 80504 Visit us online at www.aquahot.com Call us at (800) 685-4298 or (303) 651-5500 ©2019 Aqua-Hot Heating Systems, LLC. Printed in the USA...

Table of Contents