Replacing The Water Filter And Pre-Filters - Beurer maremed MK 500 Instructions For Use Manual

7. Fill the tank fully up to the MAX marking (approx. 6 litres) with fresh, cold tap water.
8. Using the measuring jug, add 90 ml of the maremed
every 1 litre of tap water use 15 ml of maremed
9. Place the evaporator block with the water filter back into the tank.
10. Place the top cover onto the housing.
11. Insert the mains plug into the device and into the mains socket. Ensure that the cable
does not pose a trip hazard.

7.6 Replacing the water filter and pre-filters

Note
Use of the UVC lamp may result in a slight brown discolouration on the water filter. Small
salt crystals may also form on the water filter if the device is used regularly.
We recommend replacing the water filter and the pre-filters with new filters after 2200 op-
erating hours. After 2200 operating hours have elapsed, the filter change indicator
light up on the touch display.
1. Once the filter change indicator
ton to switch off the maremed
2. Pull the mains plug out of the socket.
3. Remove the mains plug from the maremed
4. Replace the two pre-filters as shown.
1
5. Replace the water filter as shown.
1
681.19_MK500_2019-05-28_01_Display_BEU
6. Connect the mains plug to the socket and switch the maremed
®
® special sea salt).
lights up on the touch display, press the ON/OFF but-
.
®
.
®
2
2
34
special sea salt to the tap water (for
3
New filter
3
681.19_MK500_2019-05-28_01_Display_BEU
on.
®
will