Advertisement
INSTALLATION
A. Slide NXG-Vision Battery Pack (FIGURE 2) onto NXG-Vision Power Supply/
Charger (FIGURE 1) until NXG-Vision Battery Pack becomes fully flush with
NXG-Vision Power Supply/Charger. You should hear a "click" when NXG-Vision
Battery Pack is fully seated.
B. Connect provided AC Power Cord to AC Input Connector on bottom of NXG-
Vision Power Supply/Charger.
C. Connect 3 Prong AC Power Cord Plug End into standard 3 Prong AC
Receptacle rated for NEMA 5-15 3 Prong AC Plug.
D. Verify "System Status" LED is "On" with Green illumination
E. Connect NXG-Vision to ONT (Optical Network Terminal)
F. Ensure "System Status" LED is the only illuminated LED on NXG-Vision. If
any additional LEDs are illuminated recheck NXG-Vision Battery Pack to make
sure it is fully seated and ensure that all wiring from NXG-Vision to ONT is
installed correctly as listed by ONT specific instructions.
BATTERY REPLACEMENT
As long as AC line power is available, NXG-Vision can resume operation while
battery is replaced.
PROCEDURE:
1. Remove the NXG-Vision Battery Pack by sliding off in opposite direction of
installation (FIGURE 4) and next follow "Installation Step A" above for installing
the new NXG-Vision Battery Pack
NOTE: Please follow all State, Federal, and International Regulations when
disposing or recycling Li Ion Battery Pack.
WARNINGS - Li Ion Battery Pack
DO NOT DISASSEMBLE BATTERY PACK
DO NOT DISPOSE OF IN FIRE
CHARGE ONLY WITH SPECIFIED CHARGER
DO NOT STORE IN TEMPERATURE OVER 65C
FCC NOTICE
This equipment has been tested and found to comply with the limit for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with these instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
tuning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: (1) Reorient or relocate
the receiving antenna. (2) Increase the separation between the equipment and
receiver. (3) Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. (4) Consult the dealer or an experienced
radio/TV technician for help.
CAUTION: Any changes or modifications could void the authority granted by the
FCC to operate this equipment.
NOTE: PowerTec Solutions International reserves the right to change or correct
the contents of this document and does not assume any responsiblity for
ommissions or errors.
Continuous Power Capacity
PowerTec Solutions International
Corporate Headquarters
1290 Harbor Court
Hollywood, FL 33019
P: 615-879-3326
E: info@powertecsolutions.net
Website: www.powertecsolutions.net
Advertisement
