Table of Contents
Advertisement
Quick Links
Piscine
INSTRUCTIONS : SPA III/ SPA-IV
open, the pump will only suction from the skimmer. This is the vacuum position; the suction is only
done by the skimmer.
Pool drain position: When
the pump will only suction from the bottom drain. This is the pool drain position
(Tip: place the hose in front of a return jet to properly fill it with water).
Remove the basket from the skimmer and place the valve's red lever at the bottom of the skimmer in the vertical position. The
bottom drain will then close and there will only be a single suction concentrated in the skimmer. Re-install the basket in the
skimmer.
Connect the fixed end of the vacuum hose to the Skim-Vac. Place the Skim-Vac above the basket. This way, the debris that
could possibly block your lines will remain in the skimmer's basket. The rest of the debris that will be sucked up will be directly
sent to your filter.
Vacuum the water slowly to avoid creating too much stir and ensure an effective cleaning.
If the suction drops, look for any kind of dirt in the basket of the skimmer, the basket of the
pump and clean your cartridge.
BOTTOM SKIMMER VALVE OPERATION
This valve is found at the bottom of the skimmer, below the basket (see picture of the
skimmer).
Normal filtration position: When the
swivelling cover is
from the bottom drain. This is the normal filtration position: the suction is done by the
skimmer and bottom drain.
Vacuum position: When
the red lever is horizontal
HOW TO USE THE VACUUM CLEANER?
Connect the telescopic pole to the vacuum. Take the vacuum hose and check both ends of the
hose: one end swivels and the other is fixed. Place the swivelling end of the vacuum hose to
the head of the vacuum and lower it to the bottom of the Spa.
Fill the vacuum hose with water to eliminate the air pockets inside the hose.
red lever is horizontal
opened, the pump will suction 50% from the skimmer and 50%
the red lever is vertical
(laid down) and
Canada Ltée.
www.fibro.ca
(laid down) and the
(up) and
the swivelling cover is
the swivelling cover is
shut,
Advertisement
Table of Contents
Summary of Contents for FIBRO SPA III
- Page 1 Piscine Canada Ltée. www.fibro.ca INSTRUCTIONS : SPA III/ SPA-IV BOTTOM SKIMMER VALVE OPERATION This valve is found at the bottom of the skimmer, below the basket (see picture of the skimmer). Normal filtration position: When the red lever is horizontal...
- Page 2 SPRING FIRST CLEAN UP OR FIRST CLEAN UP FOLLOWING THE SPA INSTALLATION. ALWAYS VERIFY THE WATER LEVEL IN YOUR DRAINING WELL BEFORE LOWERING THE WATER LEVEL OF YOUR SPA. During these periods, excess of dirt is accumulated in your Spa. A special cleaning procedure is then needed.
- Page 3 DIGITAL CONTROL KEYBOARD: (for more information consult your IN.XE TechBook) To start the pump: Press key to start the pump at a low speed, press a second time to turn pump to high speed and press a third time to turn of the pump. Your system runs on 20 minutes cycles.
Need help?
Do you have a question about the SPA III and is the answer not in the manual?
Questions and answers