Global G3431 Operating Instructions, Parts List, Warranty, & Warranty Repair Center

Operating Instructions, Parts List, Warranty, & Warranty Repair Center
IMPORTANT! Read carefully before operating this tool. Failure to operate any power tool
properly can result in personal injury and/or property damage!
Free Speed (RPM) .........................7,000
Air pressure (PSI) ...............................90
Hose Size (ID) ................................... 3/8"
Air Inlet (NPT) ................................... 1/4"
Square Drive .......................................1/2"
1. Always use impact type sockets that are designed for impact wrenches.
2. Have throttle in "off" position when connecting to air supply.
3. Disconnect tool before performing service, changing accessories, or when not in use.
4. Always be in a safe working distance from others when using tools.
5. Keep tools clean and oiled for best and safest performance.
6. Follow instructions for lubricating and changing accessories.
7. Do not wear loose fitting clothing and remove watches and rings.
8. Always use proper hose and fittings. Never use quick change couplings attached at tool.
9. Keep proper footing and balance at all times.
10. Never carry tools by the hose. Keep hoses from heat, oil, and sharp edges. Check hoses
for weak or worn condition before each use, making certain that all connections are
secure.
Lubricate the tool daily with a good grade of air tool oil. The oil can be applied directly into
the air inlet of the tool and then run the tool. A rust inhibitor oil is acceptable for air tools.
Tools of this class operate on a wide range of air pressure. It is recommended that air pressure
of these tools measure 90 PSI at the tool while running free. Higher pressure and unclean air
will shorten the tool's life and may create a hazardous condition.
Water in the airline will cause damage to the tool. Ensure that the air tank is drained daily
Clean the air inlet filter screen on at least a weekly basis. The recommended hookup
procedure can be viewed in the illustration below.
Model # G3431
1/2" Impact Wrench
Max. Torque (Ft.Lbs)............................. 260
Bolt Capacity ......................................... 5/8"
Avg. Air Consump.(cfm) ........................ 4.5
Overall Length ..................................... 7.28"
Weight (Lbs) ......................................... 4.75
Safety
Lubrication
Air Supply