Advertisement
DIVINSUP-2-1X5A Manual
Reasonable prices, priceless reasoning.
Installation
It is recommended that assistance be available to safely install equipment in
equipment racks.
1.Install chassis in equipment rack (equipment rack sold separately) by supporting the bottom and rear of DIVINSUP-2-1X5Aat the desired elevation in rack.
2.Line up the side holes of chassis with the tapped equipment rack holes.
3.Insert the provided screws through the mounting holes at the extreme left and right of faceplate and thread into the tapped equipment rack holes.
4. Fasten the bottom screws first, then fasten top screws.(tighten securely).
5.Connect a cable from the satellite vertical polarity low noise block converter (LNB) to the vertical input connector of the DIVINSUP-2-1X5A.
6.Connect a cable from the satellite horizontal polarity low noise block converter (LNB) to the horizontal input connector of the DIVINSUP-2-1X5A.
7.Connect a cable from the output connector the DIVINSUP-2-1X5Ato the input of a satellite receiver
8.Plug the wall adaptor plug into the jack located in the back of the unit.
9.Plug the adaptor into a 120Vac, 60Hz wall receptacle.
3340 S. Lapeer Rd • Orion, MI 48359-1320 • Ph (248) 391-9200 • Fax (248) 391-9206 •
sales@DAWNco.com
Advertisement
