Connecting The Turbocharger; Attaching The Support - ABB A100-M Series Original Assembly Instructions

Assembly Instructions / A150-M, A155-M
4 Installing the turbocharger / 4.4 Connecting the turbocharger
4.4

Connecting the turbocharger

Connect cable to speed sensor (86515).
u
Connect all gas, water and air lines according to the instructions of the enginebuilder.
u
Version with compressor wheel cooling
CAUTION
Failure of compressor wheel cooling
Any prolonged failure of the compressor wheel cooling will shorten the re-
placement interval of the compressor wheel.
Make sure there is an uninterrupted supply of cooling air during opera-
u
tion.
Fig. 9: Connecting the compressor cooling air intake
Remove the screw plug on the connection for the compressor wheel cooling (06) and fit
u
the cooling air line.
4.5

Attaching the support

Fig. 10: Attaching the support
If present: Attach support (61301) to engine support or to a connecting piece.
u
© Copyright 2020 ABB. All rights reserved. HZTL455311P0006_EN Rev.B July 2020