Rocky Mountain 1-PIN Instructions

ROCK SOLID DEPENDABILITY
Mounting
Mount the sight to the bow in one of three positions with
the bow mounting screws provided. Set the length of the
sight by loosening the set screw on the dovetail bracket.
Slide to desired position (8 possible) and tighten set screw.
Sighting In
(20 yards recommended)
Set the top pin in the preferred position in the bezel
(using the hex key provided). Next, unlock the Tool Free
Locking Knobs, allowing the Micro Adjust Windage and
Dials to rotate. Rotate the Micro Adjust Windage and
Dials to precisely tune pin placement. Once
pins are in the desired location, lock the Tool Free Locking Knobs.
* Move pins in the same direction of desired arrow
placement.
i.e. If missing left, adjust pins left. If missing low,
move pins down.
ALUMINUM BUILT
AL
ROCK SOLID FEATURES
Micro Adjust Windage and
The Micro Adjust Windage and
the shooter to make small, consistent, and accurate
adjustments as needed. They are also useful tools for
precision sight in.
Windage Dial
The laser etched Windage Dial
precisely adjusts the pins left and
right. (clockwise moves pins left,
counter clockwise moves pins right)
.
Dial
The laser etched
the pins up and down, keeping the bezel squre to
shooters eye. (clockwise moves pins down, counter
clockwise moves pins up)
Adjustable Reset Block for Quick Return
Bump the reset block against the sight body when
the sight is sighted in at 20 yards. This will allow
the shooter to return to the same spot every time.
2nd and 3rd Axis Adjustments
Designed to further accommodate shooters sight
alignment preferences.
2nd Axis Adjustment
Loosen/Tighten screws to
adjust the 2nd axis of the sight.
3rd Axis Adjustment
Loosen/Tighten screw and pivot the
level to adjust the 3rd axis of the sight.
Built in light adapter
Use light adapter port to mount an optional light
for use in low light situations. Designed to only
illuminate the pins, keeping the target
sharp in the shooters eye.
Dials
Dials allow
.
Dial precisely adjusts