Advertisement
4. air supply
4.1.
recommended hook-up procedure is shown in fig.1.
4.1.1.
ensure spray dryer air valve is in the "off" position before connecting to the air supply.
4.1.2.
You will require an air pressure of 90psi and an air flow according to specification.
warninG! ensure the air supply is clean and does not exceed 90psi while operating the dryer. too high an air pressure
ˆ
and/or unclean air will shorten the product life due to excessive wear and may be dangerous causing damage and/or personal
injury.
4.1.3.
drain the air tank daily. Water in the air line will ruin the paint finish and damage the dryer.
4.1.4.
clean air inlet filter weekly.
4.1.5.
Keep hoses away from heat, oil and sharp edges. check hoses for wear, and make certain that all connections are secure.
4.2.
couplings
4.2.1.
movement can cause failure if a quick change coupling is connected directly to the dryer when used without optional stand, model no.
sdAst. to overcome this connect a leader hose to the dryer. A quick change coupling may then be used to connect the leader hose
to the air line recoil hose, see figs 1 and 2.
fig.1
5. operation
5.1.
connect dryer to air supply as described in section 4.
5.2.
ensure that the valve is fully anti-clockwise in the 'off' position (fig.3) and turn on the air supply.
5.3.
open the valve clockwise (fig.3) to begin air flow and regulate as required.
5.4.
the sdA03 may either be used as a handheld device or used in conjunction with sdAst double stand (fig.4) enabling the user to
leave the dryer in place.
5.5.
When finished, turn off, disconnect from the air supply and store in a dry location.
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
when the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
fig.4
fig.3
environmental protection
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
fig.2
9
01284 757500
01284 703534
sdA03.V2 issue:1 22/09/15
fig.3
8
www.sealey.co.uk
web
sales@sealey.co.uk
Advertisement
