Advertisement
3.1.7
Slowly operate the pump until the plate is close to, or just touching, the filter. Check the alignment of the crushing unit with the plate.
3.1.8
Apply increasing pressure until the filter is crushed, as shown in Fig.6. Note that the crushing unit is supplied with a ram extension. If
the press ram travel is insufficient to completely crush the filter, the ram can be retracted, the extension inserted between ram and
crushing plate and crushing completed without repositioning the press table.
3.1.9
DO NOT exceed the stroke rate indicated on the press, or the red line marked on the piston gauge.
3.1.10 On the completion of work, release the press pressure, the piston and the crushing plate head will retract automatically.
3.1.11 Ensure that the crushed filters and residual oil and sludge are disposed of according to local regulations.
3.2
OIL CRUSHER UNIT ADAPTORS
3.2.1
The adaptors OFCA50 and OFCA60, shown at Fig.1, enable Oil Filter Crusher OFC1 to be used with a wide range of bench and floor
presses.
NOTE: ALWAYS keep the press piston retracted after use to avoid corrosion.
Fig.4
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No responsibility is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For copy of our latest catalogue & promotions, call on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
Fig.6
01284 703534
Web
01284 757500
email
OFC1, OFCA50, OFCA60 - 3 - 11/12/06
Fig.5
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
