TC4400 Call-Control Console Function Keys 4. Gray Some older TC44OO’s have no hook-switch so Transfer: This is used to connect two parties together-typically, a call coming in on a “Trunk” key and an inside party on a “Monitored Extension.” If the Console is programmed for ‘Direct Transfer,”...
TC4400 Call-Control Console Notes: 1. If there are more than four call-ins “stacked 2. If an emergency call originates from a locking switch, someone must release the switch to clear the call-in. key and then dialing #-2-2, which will bring the next four However, this does not affect your ability to call this room numbers onto the display;...
TC4400 Call-Control Console With Pre-Screening Remote Hookflash Press What it is: Ifyou receive a call from a CentrexW or PI3X Transfer. LED on the caller’s DS key will flash at the system and want to transfer this call back to another lint “hold”...
Call-Control Console TC4400 press a Telecenter key and dial one of the Wait for a tone, then make the announcement. Press To page, following codes: to end the page. Release Time-tone signals will override paging. If you Note: Code Type of Page...
V’ in the display correspond with the Step 4. Remove the bar holding the central unit’s version of software currently installed in the TC4400. modules in place. Orient the Interface Module so that its If your TC4400 software is earlier than version Note: 10.0, and so does not show the software version on the...
“crash” between an incoming and or single-line phone whose Physical Number is stored an outgoing call (see Note 1, below). here. Putting a 0 here tells the system that a TC4400 is being used. ministrative phones enables them to pick up calls from...
Page 9
TC4400 Call-Control Console Numbers (wiring per the TC4 manual) and Physical Num- associated circuits. For each Physical Number, a set of bers to the keys (built into the software). “‘Attributes” can be stored and referred to as “N: A: B: Z:”...
TC4400 Call-Control Console Troubleshooting Note: Internal DIP switches I and 2 must be set cor- Step 4. To rule out problems with field wiring, bring rectly for operation with Version 10.0 and later Console the Console and its power supply to the TC4001 and plug them in for local operation as described in the attached software.
TC4400 Call-Control Console TC4400 Software Revision History Version 6 (Checksum: CB8Bh; First Release) Version 8 (Checksum: D255h; Released 2/7/89) switch 2 Console Switch 1 Enhancements All keys were given leading-edge response. AI1 actions occur as soon as the key is depressed: they do not wait until the key is released.
Page 14
Console-C Digit Arch. #: 1 (trunk), 2 (TC line), 3 (monitored ext.) hunt direction Dialing number to access that line. Digit The “inside,” or “Architectural,” number Phys. #: = The “Physical Number” The “A” Attributes The “B” Attributes Location Codes (Partial) Function: Location: Setting:...