Super Flower POWER SUPPLY User Manual

PRECAUTIONS BEFORE INSTALLATION:

1. The user's input voltage (AC INPUT) must conform with the power supply regulations.
(Full voltage using range: 100Vac ~ 240Vac)
2. If the product is a passive power supply, please switch to change the voltage from the
base of the power supply. (115V for Taiwan, Japan, and the United States and 230V for
most of the Eurasian countries).
3. Please confirm that the components (chassis, CPU, motherboard, graphics card, hard
disk, etc.) in the new system must meet the relevant regulations and requirements.
(After the host chassis assembling is completed, please consult the second step,
IMPORTANT SAFETY INSTRUCTIONS, from point 5 to10 to install the power supply).
4. When replacing the components, it is recommended to be assessed by the host
component authorized service provider whether there are any abnormal conditions to
prevent any unpredictable circumstances.
5. Please arrange the power cord and the extension cord rating carefully to avoid
overload conditions.
6. Take the power supply out from the package, make sure the switch stays in the OFF
( I/O switch to"O").

IMPORTANT SAFETY INSTRUCTIONS:

Check the power supply voltage before installation. It should be the same as your local
power voltage (115V or 230V for most of the European countries).
Change the voltage setting if necessary.
1. Make sure the computer turns off normally.
2. Disconnect the power cord from your old power supply (I/O switch to"O"stays OFF).
3. Disconnect all the power connectors from the motherboard and the periphera
devices such as hard drives, floppy drives, etc.
4. Remove the old power supply from your computer case and replace it with the power
supply.
5. Please retain enough spaces for the power supply fan location with other computer
system components to ensure the stability of the wind inhalation.
6. Connect the power connectors to your motherboard and peripheral devices.
7. After the connection is completed, check if the wiring is abnormal or loose conditions.
8. Close the computer case and check if wire is stuck or pressed.
9. Take out the AC power cord from the product (specifications will be different
depending on the wattage and the product).
10. Connect the power cord to the power supply (I/O switch to"I"stays ON).

SAFETY CERTIFICATIONS:

180907-2
POWER SUPPLY USER GUIDE