Download Print this page

Adjust Screen - Sealey HBS2001 Manual

Bodyshop/workshop headlamp beam setter

Advertisement

fig.8
9.1.
Using the calibrated spirit level within the laser alignment calibration device, ensure that the unit is flat and level.
9.2.
Switch the laser on. Manoeuvre the beam setter in order to centre the laser beam in the beam setter lens. This must be done "by eye".
There is a ±20mm tolerance on centralisation of the beam through the lens. The beam setter should be approximately 2m from the
laser.
9.3.
The dot projected onto the aiming screen should bisect the 0º line, at the far left, centre and far right of the screen. It is necessary at
this point to rotate the column through the vertical axis, to track the beam from one side of the aiming screen to the other. Take care to
ensure that the laser and the beam setter box (see Section 10) remain level throughout.
9.4.
To adjust the aiming screen, use the two holding screws.
9.4.1.
loosen the screws and reposition the screen, so that the projected laser dot correctly bisects the 0º line.
9.4.2.
Retighten the screws, taking care not to move the screen back out of position.
Aiming screen
Holding screws
fig.10
10. OTHER INfORMATION
The Headlamp Beam Setter is equipped with a spirit level located on the base of the optical box, which is visible through the transparent panel. To
level the box, loosen screws (fig.3.A & B) located on the side of the box and adjust the box until the spirit level registers horizontal. Re-tighten the
screws. The box level must be checked every time it is used on a different working surface.
11. MAINTENANcE
11.1.
The paint work is detergent resistant. Clean with a damp cloth, removing any stains. A small amount of alcohol may be applied to
stubborn areas of grime.
DO NOT leave the machine in areas where corrosive vapour is present, i.e. from battery charging or paint spraying etc.
11.2.
11.3.
DO NOT oil the column.
10.4.
An optical box dust cover is available upon request.
© Jack Sealey limited
Beam setter lens
laser device
Alignment oK

Adjust screen

Adjust screen
Original Language Version
fig.9
HBS2001 Issue 3 (HF) 14/08/18

Advertisement

loading