Advertisement
5. ASSEMBLY
Unpack the product and check contents to ensure no parts are damaged. Should there be any damaged or missing parts contact your supplier
immediately. Follow the step by step illustrations to assemble your bench.
STEP 1
Lay the wooden worktop/jaws (1) upside down on a surface that will
not scratch or cause damage. Screw the slide bases (2) to the jaws
using wood screws (8) ensuring that the jaw angle and ruler guides
are on the same side as the vice handles at point "A".
Note: If not already assembled, push handles onto vice screw ends
and secure with pins.
Align the crossbars (4) with holes in legs and insert screws (9) from
the outside and fix with washers (13) and nuts (10).
Push the plastic feet (6) onto the leg ends ensuring the longest side of
the foot corresponds with the outer corner of the leg point.
Parts support is available for this product. Please email sales@sealey.co.uk or telephone 01284 757500
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
STEP 3
01284 703534
sales@sealey.co.uk
Original Language Version
Open the leg frames (5) and align with holes on the inside of the vice
arms at points "B" ensuring the curvatures on the lower part of the legs
"Y" point outward. Insert bolts (3) from the outside of the vice arm with
washers (7) and secure with washers (7) and nuts (11) from the inside.
STEP 4
Fix chock (12) in suitable holes located in worktop as required.
Y
STEP 2
www.sealey.co.uk
FWB1.V3 Issue:2 (H,F) 15/07/20
Advertisement
