Advertisement
5. OpeRATIOn
WARnIng! measure the outer diameter of the spring to be compressed and select the correct set of
‰
jaws.
▲
DANGER! DO nOT compress the spring to an extent where the coil windings touch. (see fig.2-A)
ensure that the centre line of the spring remains parallel to the compressor body at all times.
9
this applies to both straight springs and conical springs. the spring should not be touching the piston
or body of the compressor. (see fig.2-B)
secure the strut with a clamp, vice or other adequate holding device.
9
Before use check compressor assembly for signs of damage and particularly ensure jaws are in
9
good condition and securely mounted.
5.1.
To Compress a Strut Removed From a Vehicle.
5.1.1.
screw the selected jaws onto the ram body and the piston respectively. ensure that the recessed
sides of the jaws are facing each other.
5.1.2.
slacken the breather plug to allow the cylinder to breathe on the low pressure side of the piston.
5.1.3.
Operate the pump handle (see fig.1) to drive the jaws together to the approximate length of the
spring and to allow compression of as many windings as possible.
5.2.
Place the spring strut compressor onto the spring, ensuring the spring seats correctly into both
the upper and the lower jaws and cannot slide out during compression. (see fig.2-D & E)
5.2.1.
Ensure that the centre lines of the spring and compressor body are parallel. (see fig.2).
5.2.2.
operate the pump handle (see fig.1) and compress the spring until the upper support bearing is free
and the spring will rotate.
5.3.
To Decompress a Strut Removed From a Vehicle.
5.3.1.
To decompress the spring, open the valve slowly to open the jaws (fig.1).
5.3.2.
tighten the breather plug after use to avoid accidental oil leakage in transit.
6. mAInTenAnCe
6.1.
Before each use check the compressor to ensure it is not damaged or worn. if suspect do not use
the unit, but contact your local sealey dealer who will be able to advise you.
6.2.
After use, release the hydraulic pressure and grease the piston rod using lm grease.
6.3.
Keep the compressor clean, and when not in use store in a safe, dry, childproof location.
parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImpORTAnT: no liability is accepted for incorrect use of this product.
WARRAnTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
environmental protection
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
01284 757500
01284 703534
Vs7011.V3| issue 6 06/02/17
fig.2
fig.2.
www.sealey.co.uk
Web
sales@sealey.co.uk
Advertisement
