Introduction Thank you for purchasing the Galaxy Audio JIB/CT Cable Tester. The CT is designed to test a wide variety of commonly used audio cables and quickly answer the question, “Is this cable good or bad?” A unique computer controlled circuit tests the cable 200 times per second, which allows the CT to detect and display intermittent problems that other cable testers fail to catch.
Operation 1. Battery Installation: Switch to OFF position. Remove the Battery Drawer and install a 9-volt alkaline battery, being careful to not pinch any of the wires when reinstalling the Drawer. Due to the low power consumption design and the Auto Shutoff feature, the battery life of a standard 9V alkaline should be over 100 hours.
NUMBER OF CONDUCTORS CABLE TYPES (Switch position) ¼” Mono (TS) Guitar / Line, ¼” Speaker, 1/8” Mono (TS) Line, Single RCA (use only the L (Mono) jacks on CT), NL2 Speakon Cables (and 4 conductor NL4 Speakon connectors wired for 2 conductor service), and 2 conductor adapter cables that have mismatched connectors of the above types.
CABLE SWITCH INDICATIONS TYPE POSITION Any 2 Test in two steps. Plug Common connector into “A” Conductor side of CT and one of “Y’d” ends into “B” side. LEDs (Mono) “Y” indicate Pass/Fail. Unplug first “Y’d” end and plug in Cables second “Y’d”...
7. Custom Cables. The CT is designed to test industry standard and commercially available cables and adapters. The CT may not give accurate results for cables wired otherwise. NOTES...
5. Damage occurring during the shipment or delivery of any GALAXY AUDIO product to GALAXY AUDIO after initial delivery of the product to you. 6. Damage to any GALAXY AUDIO product which has been altered, or on which the serial number has been effaced or removed.
Page 10
GALAXY AUDIO 601 E. Pawnee Wichita, KS 67211 (316) 263-2852 (800) 369-7768 Fax: (316) 263-0642 www.galaxyaudio.com Specifications subject to change without notice.