MAS Flex Series Control Manual

MAS-210 Flex controls

Switching in operation:

The MAS-210 flex is shipped with all switches in the Default or Neutral setting.
This is a good place to start when finding desired tone. The instrument signal chain can
be adjusted and optimized prior to moving the Loudspeaker from its Neutral setting.
The Arming Switch SW1 on the 210 Flex allows a third voicing in the
Bright/Dark SW2 switch. With the Arming Switch SW1 in the Default setting (Neutral)
the Bright/Dark switch is not allowed access to the internal PXB circuit thereby not
allowing the Dark voicing. In this mode the Bright/Dark SW2 switch will only change
As illustrated in the picture at the left there are
spaces for four switches.
Top: The tweeter control switch. This switch
will allow selection of one, two, or no tweeters.
The default setting is (marked with an *) the
single tweeter setting.
Bottom: The Voicing control Switch. This
controls the signal phase between the Mid/High
section and the Woofer section. The default
setting (marked with an *) is in phase.
Arming Switch SW1: This switch arms or
disarms the DARK setting in SW2. The default
setting (marked with an *) is Neutral or Off.
Bright/Dark SW2: This switch controls
Mid/High output in relation to the Woofer
section. The default setting (marked with an *)
is Dark. However, unless the Arming Switch
SW1 is lifted to the Arm SW2 setting SW2
remains in the Neutral setting and the Dark
setting is not enabled.
Placing all the switches in their Default settings
places the cabinet in a Neutral voicing with an
even response curve. In this setting the cabinet
is +/- 7db from 35Hz to 16Khz.