SAFETY WARNINGS • Before attempting installation, the Installation Manual must be fully read and understood. • When choosing a suitable position for installation, consideration should be made to avoid external influences which may damage the unit, shorten its life, or make the unit unsafe. Places to avoid include: 1.
INSTALLATION Remove the wired controller from the backing plate using a flat headed screwdriver in the gap between the backing plate and the controller. Once the two parts are separated, the remainder can be unclipped. Pass the signal wire through the opening in the rear of the backing plate, ensuring it is positioned so it will not be trapped or damaged during installation.
CONTROL PANEL Power Standard wire controller Mode Timer Clock speed Sleep Enter mode Time Temperature Swing DISPLAY Dehumidify Mode Heating Mode Clock Cooling Fan Mode Desired Mode Temperature Sleep Swing Room Temperature Error Timer indicator Fan Speed display...
OPERATION POWER BUTTON: Press to turn the air conditioner ON and OFF MODE BUTTON: While the air conditioner is operating press the mode button to change between the 4 modes. The current mode will be shown on the display. Heating Mode Dehumidify Mode Fan Mode Cooling Mode...
Disconnect the signal wires from the rear of the wired controller. Pass the signal wire through the opening in the rear of the backing plate, ensuring they are not damaged during removal. electriQ UK Support www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line.