Important Safety Instructions - Ranger CB-30L Installation And Operation Manual

Please read entire manual prior to installation. Do not operate this machine until you read and understand all the
dangers, warnings and cautions in this manual. Stay clear of any moving parts that may fall and cause injury. When
using your CB-30L Cool Boss Portable Evaporative Air Cooler basic safety precautions should always be followed,
1. Read and understand instructions and
all warning labels.
2. NEVER operate if there is any damage
to the plug or cord.
3. DO NOT route power cord under car-
peting or flooring.
4. ALWAYS unplug the electric cord
before performing inspections or repairs.
5. NEVER cover power cord with throw
rugs, runners or similar coverings.
6. ALWAYS remove plug from electrical
receptacle by pulling on the plug and not the cord.
7. Minimize trip hazard by routing power cord away from
pedestrian traffic areas.
8. Plug into three-prong grounded GFCI protected
electrical receptacle only.
9. NEVER step on or roll over power cord with heavy or
sharp objects.
10. DO NOT operate unit unless media pads are securely
in place.
11. DO NOT operate this equipment with any covers,
panels or inserts removed.
12. ALWAYS test the GFCI receptacle or breaker monthly
to ensure proper function.
13. DO NOT operate near open containers or flammable
liquids or gases.
14. Ensure cooler pumps are running continuously to
saturate and wet media pads at all times during
operation.
15. ALWAYS maintain a distance of at least 50 feet from
any open flame or sparks.
16. NEVER spray or wash unit with a garden hose as
water may harm motor and other electrical system
components.

IMPORTANT SAFETY INSTRUCTIONS

including the following:
17. DO NOT use an extension cord or cord adapters with
this portable cooler.
18. NEVER remove ground prong from plug end.
19. DISCONNECT POWER before servicing or removing
any panels, covers and doors.
20. Plug into a grounded three-prong GFCI protected
receptacle only.
21. Check power outlet for correct polarity before use.
22. DO NOT open control box compartment. No
serviceable parts located inside.
23. DISCONNECT POWER CORD before changing
media or opening fan housing.
24. NEVER modify this equipment in any way or warranty
will be voided.
25. All repairs must be done by authorized technician.
IMPORTANT
REQUIRED POWER SOURCE
Before connecting power supply, check to
see if unit is equipped with a dual-voltage
selector switch. If so, position switch
setting to correct inline voltage. Connect
to proper 115/208-230 volt AC, 50/60Hz,
1-phase, 20 amp, fused and grounded
electrical supply.
It is recommended that a separate circuit serving only
the cooler unit be provided. Use an outlet that cannot be
turned off by a switch. DO NOT use an extension cord.
When making electrical connections, insure that local
and national codes are adhered to. Use only with GFCI
protected receptacles
4