Advertisement
4. OPERATION
4.1.
With the vehicle elevated on a lift, lay the support on the floor beneath to set it to approximate size.
4.2.
To alter the arm length, pull the support arm stop (fig.1.7) to release the arm and extend. Lock at the required length with the support arm
lock (fig.1.8).
4.3.
Wind the support pad down to allow clearance when fitting.
4.4.
The hooks (fig.1.1) are designed to hook over or through the main crossmember. Adjust them to the correct distance and lock in place
using the slide locks (fig.1.2).
4.5.
Offer up to the vehicle and locate by swinging the hooks over the crossmember to suspend the support (fig.2).
Take care not to trap any pipes or wiring.
Tighten the hook tensioners to bring the support up to the chassis, making sure that the hooks are firmly located and not likely to slip.
4.6.
Swing the articulated arms (fig.1.12) to bring the reaction rods (fig.1.9) to a suitable point on the floorpan and screw them into light
contact.
Take care that the area of floorpan selected is in sound condition.
4.7.
Elevate the support pad carefully under the gearbox/engine using a spanner on the hex formed at the top of the thread (fig.3).
4.8.
When the required support has been achieved, lock the support pad using the upper and lower lock nuts (figs.1.5 & 1.6).
4.9.
When the task is finished, remove the unit in the reverse of the installation procedure. Make sure that it is removed before lowering
the vehicle.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre
and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable dispose of it according to
local regulations.
NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
fig.1
fig.2
Environmental Protection
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business
Park, Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Key
1 . . . . . Hooks
2 . . . . . Slide Locks
3 . . . . . Hook Tensioners
4 . . . . . Support Pad
5 . . . . . Lower Lock Nut
6 . . . . . Upper Lock Nut
7 . . . . . Support Arm Stop
8 . . . . . Support Arm Lock
9 . . . . . Reaction Rods
10 . . . . Reaction Rod Lock Nuts
11 . . . . Support Arm
12 . . . . Articulated Arms
fig.3
01284 757500
01284 703534
www.sealey.co.uk
sales@sealey.co.uk
VS0110 Issue:1 - 14/09/15
Advertisement
