Alex SUPER ART TABLE 711W Manual

Alex SUPER ART TABLE 711W Manual

Advertisement

TOOLS: Phillips head screwdriver required.
1 Table top
2 Paper roll holders
12 Bench
washers
WARNING:
SMALL PARTS
CHOKING HAZARD -
Not for children under 3yrs.
Caution: Keep screws, small parts and plastic bags out of children's
#711W
©2008 ALEX: Northvale, NJ 07647
2 Bench tops
2 Plastic stars
4 Table
washers
Adult assembly required
reach during and after assembly

Preparing the chalkboard surface:

You will need a piece of chalk and paper towel.
First, holding the piece of chalk horizontally, rub
the chalk over the entire chalkboard surface.
Next, take the paper towel and, using a circular
motion, rub the towel over the chalkboard
surface. Finally, erase the chalk off the entire
surface. You have just seasoned your chalkboard
and it is ready for use.
12 Bench legs 4 Table legs
1 Dowel
4 Flat tipped screws
Visit our website at www.alextoys.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUPER ART TABLE 711W and is the answer not in the manual?

Questions and answers

Summary of Contents for Alex SUPER ART TABLE 711W

  • Page 1 SMALL PARTS CHOKING HAZARD - Not for children under 3yrs. Adult assembly required Caution: Keep screws, small parts and plastic bags out of children's reach during and after assembly #711W ©2008 ALEX: Northvale, NJ 07647 Visit our website at www.alextoys.com...
  • Page 2 Using the four flat tipped screws screw the paper roll holders in place under the table. DO NOT OVER TIGHTEN! #711W ©2008 ALEX: Northvale, NJ 07647 Visit our website at www.alextoys.com...
  • Page 3 Pull the loose end of the paper roll up through the slot in the desk and thread it under the paper cutter bar. #711W ©2008 ALEX: Northvale, NJ 07647 Visit our website at www.alextoys.com...

Table of Contents